Read Sony XR-1800 / XR-1803 / XR-1804 Service Manual online
– 11 –
4. Repeat the above adjustment for the REV PB mode.
5. Check that output level difference between FWD PB mode
5. Check that output level difference between FWD PB mode
and REV PB mode is within 4 dB.
Adjustment Location: PB head
Tape Speed Adjustment
Setting:
Procedure:
1. Put the set into the FWD PB mode.
2. Adjust adjustment resistor for inside capstan motor so that the
1. Put the set into the FWD PB mode.
2. Adjust adjustment resistor for inside capstan motor so that the
reading on the speed checker or frequency counter becomes in
specification.
specification.
Specification: Constant speed
Adjustment Location: See page 13.
See the adjustment location from on page 13 for the
adjustment.
adjustment.
Speed checker
Frequency counter
–2 to +3%
2,940 to 3,090 Hz
TUNER SECTION
XR-1800 E model, a tuner section is no adjustment.
0 dB=1 µV
Cautions during repair
When the tuner unit is defective, replace it by a new one be-
cause its internal block is difficult to repair.
cause its internal block is difficult to repair.
Note:
Adjust the tuner section in the sequence shown below.
1. FM Auto Scan/Stop Level Adjustment
2. FM Noise Focus Adjustment
3. FM Stereo Separation Adjustment
4. MW Auto Scan/Stop Level Adjustment
2. FM Noise Focus Adjustment
3. FM Stereo Separation Adjustment
4. MW Auto Scan/Stop Level Adjustment
FM Auto Scan/Stop Level Adjustment
Setting:
[TUNER]
button: FM 1
FREQUENCY SELECT switch: FM50 k (XR-1804 only)
Procedure:
1. Tune the set to 98.0 MHz.
2. Connect the digital voltmeter to TP2 (SD) on MAIN board.
3. Adjust RV2 on TU100 so that the reading on the digital volt-
1. Tune the set to 98.0 MHz.
2. Connect the digital voltmeter to TP2 (SD) on MAIN board.
3. Adjust RV2 on TU100 so that the reading on the digital volt-
meter changes point from low to high.
Adjustment Location: See page 13.
FWD
REV
adjustment
screws
screws
+
–
speed checker
or
frequency counter
test tape
WS-48A
(3 kHz, 0 dB)
WS-48A
(3 kHz, 0 dB)
speaker out terminal
set
4
Ω
FM RF signal
generator
dummy
antenna
Carrier frequency : 98.0 MHz
Output level
Output level
: 28 dB (25.1
µ
V)
Mode
: mono
Modulation
: 1 kHz, 22.5 kHz deviation (30%)
antenna
jack (CN900)
jack (CN900)
set
50
Ω
50
Ω
0.1pF
+
–
–
TP2 (SD)
MAIN board
digital
voltmeter
voltmeter
Click on the first or last page to see other XR-1800 / XR-1803 / XR-1804 service manuals if exist.