XAV-W600, XAV-W650BT - Sony Car Audio Service Manual (repair manual). Page 5

DESTINATION  SETTING  METHOD
When the chassis main assy (CHA1) is replaced, the destination 
setting is necessary.

 Remote commander is necessary.

 

    It is necessary to operate by the remote commander, even in case of 

models that have not been supplied the remote commander.

  

 

(Refer 

to 

“ACCESSORIES” on page 28 about the remote com-

mander)

 It is not necessary for US, Canadian and MARUTI SUZUKI mod-

els to perform the destination setting. Check whether correct des-
tination is set, refer to “Destination setting checking method” on 
page 6. If correct destination is not set, perform the destination 
setting according to the following procedure.

  

 

(When 

correct 

destination has been set for MARUTI SUZUKI  

model, “MURUTI SUZUKI” screen is displayed on the screen at 
startup. (Refer to Note in the “MODEL IDENTIFICATION” on 
page 4))

1.  Preparing the Destination Setting
Be sure to solder the SL001 on the MAIN board before doing the 
destination setting.

Set destination according to the procedure below.

2-1.  Setting the Destination Code
1.  Turn the power on this unit.
2.  Press the [OFF] button on the remote commander.
3.  In the state of source off (Home screen is displayed), enter the 

destination setting mode by pressing the buttons on the remote 
commander in order of the [4] t [5] t [6] (press only the [6] 

button for two seconds).

4.  The following screen is displayed and the destination setting 

mode becomes effective.

 

(Displayed characters/values in the following fi gure  are  ex-
ample)

 Refer to following “2-2. Entering the Destination Code” for opera-

tion method.

<DESTINATION SETTING MODE>

0

  0   0   0   0   0

E U R :   0 0 0 0 0 0

E 1 7 :   0 0 0 0 1 2

R U 2 :   0 0 0 0 0 4

E A :   0 0 0 0 1 A

U C :   0 0 0 0 0 1

E :   0 0 0 0 0 3

I N 3 :   0 0 0 0 1 6

E T 4 :   0 0 0 0 1 C

5.  The resetting operation is executed by pressing the reset button  

after the setting ends, and the unit returns to the normal condi-
tion.

 Input of the destination code cannot be performed by the keys of 

main unit. Be sure to input the destination code by remote com-
mander.

 The model to which the remote commander is not attached can 

also be operated by using the remote commander.

 The number buttons on the remote commander cannot be used.

1. Press the [V] or [v] button, and select the alphanumeric char-

acter of “0 to F”.

2.  The digit advances by pressing the [b] button.

 

The digit returns by pressing the [B] button.

3.  The setting is completed by pressing the [ENTER] button, and 

the initialization operation is done.

AEP and UK models (EUR)

000000

US and Canadian models (UC)

000001

E (NTSC) model (E)

000003

Russian model (RU2)

000004

E (PAL) model (E17)

000012

Indian model (IN)

000015

MARUTI SUZUKI model (IN3)

000016

Saudi Arabia model (EA)

00001A

Australian model (ET4)

00001C

– Continued on next page –