XAV-W1 - Sony Car Audio Service Manual (repair manual). Page 5

5

1. When the user is setting the security code, after the cold start,

the following screen is displayed on the monitor.

2. When you know the security code, touch the number of security

code on the monitor. When the security code agrees, screen
shifts to the initial setting screen. (Even if you make a mistake
in the security code, you can input it again and again)

3. When you don’t know the security code, press the button of

remote commander in order of [ENTER] 

→

 [5] 

→

 [4] 

→

 [1]

→

 [5] 

→

 [ENTER] (master code). When the master code agrees,

screen shifts to the initial setting screen. (Even if you make a
mistake in the master code, you can input it again and again)

4. When the user isn’t setting the security code, after the cold

start, the following screen is displayed on the monitor.

5. Touch the “OK” button on the monitor to display the normal

screen on the monitor.

1. Touch the “SETUP” button on the monitor to display the

following screen (setup screen) on the monitor.

2. Touch the “Security Control” button on the monitor.
3. When the user is setting the security code, the following screen

is displayed on the monitor.

4. When you know the security code, touch the number of security

code on the monitor. (When you don’t know the security code,
refer to 2. releasing method after cold start) When the security
code agrees, screen shifts to the setup screen. (Even if you
make a mistake in the security code, you can input it again
and again)

5. When the user isn’t setting the security code, the following

screen is displayed on the monitor.

6. You can set the security code by inputting the same code twice

with remote commander.