Read Sony XAV-A1 Service Manual online
2
XAV-A1
Notes on chip component replacement
•
Never reuse a disconnected chip component.
•
Notice that the minus side of a tantalum capacitor may be
damaged by heat.
Flexible Circuit Board Repairing
•
Keep the temperature of the soldering iron around 270 ˚C
during repairing.
•
Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
•
Be careful not to apply force on the conductor when soldering
or unsoldering.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.
other than those specified herein may result in hazardous radiation
exposure.
CAUTION
The use of optical instruments with this
product will increase eye hazard.
As the laser beam used in this CD/DVD
player is harmful to eyes, do not attempt to
disassemble the cabinet. Refer servicing to
qualified personnel only.
This label is located on the bottom of the chassis.
This product is classified as a CLASS 1 LASER PRODUCT.
This product is classified as a CLASS 1 LASER PRODUCT.
This label is located on the top exterior.
ATTENTION AU COMPOSANT AYANT RAPPORT
À LA SÉCURITÉ!
LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE
0
SUR
LES DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES
PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ DE
FONCTIONNEMENT. NE REMPLACER CES COM- POSANTS
QUE PAR DES PIÈCES SONY DONT LES NUMÉROS SONT
DONNÉS DANS CE MANUEL OU DANS LES SUPPLÉMENTS
PUBLIÉS PAR SONY.
PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ DE
FONCTIONNEMENT. NE REMPLACER CES COM- POSANTS
QUE PAR DES PIÈCES SONY DONT LES NUMÉROS SONT
DONNÉS DANS CE MANUEL OU DANS LES SUPPLÉMENTS
PUBLIÉS PAR SONY.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK
0
OR DOTTED LINE
WITH MARK
0
ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
– US, Canadian models –
Amplifier section
Outputs
Speaker outputs
(sure seal connectors)
(sure seal connectors)
Speaker impedance
4 - 8 ohms
50 W
×
4 (into 4 ohms, at 1 kHz)
General
12 V DC, from car battery (negative
ground)
Max. 10 A
Inputs
Power supply (1)
AUX (3)
AUX (3)
Outputs
Front PRE out (1)
Rear PRE out (1)
Subwoofer (mono) (2)
Power aerial relay control lead (1)
Power amplifier control lead (1)
Rear Monitor OUT (1)
Bass
Rear PRE out (1)
Subwoofer (mono) (2)
Power aerial relay control lead (1)
Power amplifier control lead (1)
Rear Monitor OUT (1)
Bass
±
10 dB at 100 Hz
Treble
±
10 dB at 10 kHz
Dimensions
With monitor closed
Approx. 178
Approx. 178
×
50
×
185 mm (W
×
H
×
D)
Mass
Approx. 1.7 kg
Remote commander RM-X706 (1)
(incl. 1 lithium battery)
Parts for installation and
connections (1 set)
Design and specifications are subject to
change without notice.
change without notice.
Maximum power output
Power requirements
Consumption current rating
Tone controls
Supplied accessories
Operating Instructions (1 set)
Connection box for XM tuner (1)
(US, CND, E (NTSC))
Connection box for XM tuner (1)
(US, CND, E (NTSC))
AM
Tuning range
Tuning range
10.8 MHz / 450 kHz
Usable sensitivity
30
µ
V
Intermediate frequency
530 - 1,710 kHz (US, CND, E (NTSC))
531 - 1,602 kHz (RU, E (PAL), AUS, CH)
531 - 1,602 kHz (RU, E (PAL), AUS, CH)
•
Abbreviation
AUS
AUS
: Australian model
CH
: Chinese model
CND : Canadian model
RU
RU
: Russian model
This label is located on the bottom of the
chassis.
chassis.
Click on the first or last page to see other XAV-A1 service manuals if exist.