Read Sony MEX-DV1100 / MEX-DV2100 Service Manual online
MEX-DV1100/DV2100
5
EXTENSION CABLE AND SERVICE POSITION
When repairing or servicing this set, connect the jig (extension
cable) as shown below.
When repairing or servicing this set, connect the jig (extension
cable) as shown below.
• Connect the MAIN board (CN101) and the SERVO board
(CN3) with the extension cable (Part No. J-2502-107-1).
NOTE FOR FLEXIBLE BOARD OF THE OPTICAL
PICK-UP
When connecting or disconnecting the fl exible board of the opti-
cal pick-up to or from the CN2 of the SERVO board, follow the
procedure given below.
PICK-UP
When connecting or disconnecting the fl exible board of the opti-
cal pick-up to or from the CN2 of the SERVO board, follow the
procedure given below.
Note: When soldering the short lands, solder within 5 seconds at the
temperature of soldering iron below 300°C.
Disconnection:
1. Solder two shortland.
2. Disconnect the fl exible board from the CN2 of the SERVO
1. Solder two shortland.
2. Disconnect the fl exible board from the CN2 of the SERVO
board.
Connection:
1. Connect
1. Connect
the
fl exible board to the CN2 of the SERVO board.
2. Unsolder two shortland.
SERVO board
(CN3)
(CN3)
MAIN board
(CN101)
(CN101)
extension cable
(Part No. J-2502-107-1)
(Part No. J-2502-107-1)
NOTE FOR REPLACING THE MOUNTED MAIN
BOARD
If the mounted MAIN board was replaced, be sure refer to Techni-
cal News published separately.
BOARD
If the mounted MAIN board was replaced, be sure refer to Techni-
cal News published separately.
NOTE FOR REPLACEMENT OF THE AUX JACK
(J901)
To replace the AUX jack requires alignment.
1. Insert the AUX jack into the KEY board.
2. Place the KEY board on the front panel.
3. Solder the three terminals of the jack.
(J901)
To replace the AUX jack requires alignment.
1. Insert the AUX jack into the KEY board.
2. Place the KEY board on the front panel.
3. Solder the three terminals of the jack.
KEY board
front panel
AUX jack
Click on the first or last page to see other MEX-DV1100 / MEX-DV2100 service manuals if exist.