MEX-DV1000, MEX-DV2000 - Sony Car Audio Service Manual (repair manual). Page 2

2

Outputs: 

Video output terminals (front/rear) (DV2000)
Video output terminal (DV1000)
Audio output terminals (front/rear) (DV2000)
Rear audio output terminals (DV1000)
Center output terminal (DV2000)
Subwoofer output terminal (DV2000)
Power antenna (aerial) relay control terminal
Power amplifier control terminal

Inputs: 

Telephone ATT control terminal (DV2000)
Illumination control terminal (DV2000)
BUS audio input terminals
BUS control input terminal
Remote controller input terminal
Antenna (aerial) input terminal
Parking break control terminal
Microphone input terminal
AUX input jack (stereo mini jack)

Power requirements: 12 V DC car battery 

(negative ground (earth))

Dimensions: Approx. 178 

× 50 × 181 mm 

(7 

1

/

8

 

× 2 × 7 

1

/

4

 in) (w/h/d)

Mounting dimensions: Approx. 182 

× 53 × 181 mm 

(7 

1

/

4

  

×  2 

1

/

8

  

×  7 

1

/

4

 in) (w/h/d)

Mass: Approx. 1.4 kg (3 lb 2 oz)
Supplied accessories: 

Card remote commander: 
RM-X161 (DV2000: US and Canadian models)

Parts for installation and connections (1 set)

Your dealer may not handle some of the above 
listed accessories. Please ask the dealer for 
detailed information.

RM-X162 (DV2000: Russian model)
RM-X163 
(DV2000: E, Indian and Chinese models)

RM-X167 
(DV1000: E, Indian and Chinese models)

RM-X166 
(DV1000: AEP, UK and Russian models)

DivX, DivX Certified, and associated logos are 
trademarks of DivX, Inc. and are used under 
license.

Note
This unit cannot be connected to a digital 
preamplifier or an equalizer which is Sony BUS 
system compatible.

Design and specifications are subject to change 
without notice.

US and foreign patents licensed from Dolby 
Laboratories.

MPEG Layer-3 audio coding technology and 
patents licensed from Fraunhofer IIS and 
Thomson.

• Never reuse a disconnected chip component.

• Notice that the minus side of a tantalum capacitor may be

damaged by heat.

• Keep the temperature of the soldering iron around 270 ˚C

during repairing.

• Do not touch the soldering iron on the same conductor of the

circuit board (within 3 times).

• Be careful not to apply force on the conductor when soldering

or unsoldering.

Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.

This label is located on the drive unit's internal
chassis

This label is located on the bottom of the
chassis.

 0

0

0

-

This label is located on the drive unit’s internal
chassis.