CDX-M620, CDX-M670 - Sony Car Audio Service Manual (repair manual). Page 2

Read Sony CDX-M620 / CDX-M670 Service Manual online

2
optical pick-up block
semi-fixed resistor
SERVICE NOTES
SAFETY-RELATED  COMPONENT  WARNING!!
COMPONENTS  IDENTIFIED  BY  MARK  
0
  OR  DOTTED  LINE
WITH  MARK  
0
  ON  THE  SCHEMATIC  DIAGRAMS  AND  IN
THE  PARTS  LIST  ARE  CRITICAL  TO  SAFE  OPERATION.
REPLACE  THESE  COMPONENTS  WITH  SONY  PARTS  WHOSE
PART  NUMBERS  APPEAR  AS  SHOWN  IN  THIS  MANUAL  OR
IN  SUPPLEMENTS  PUBLISHED  BY  SONY.
Inputs
Telephone ATT control
lead
Illumination control lead
BUS control input connector
BUS audio input connector
Antenna input connector (US model)
Aerial input connector (AEP, UK, E model)
AUX IN connector (US model)
Tone controls
Bass ±8 dB at 100 Hz
Treble ±8 dB at 10 Hz
Loudness
+8 dB at 100 Hz
+2 dB at 10 Hz
Power requirements
12 V DC car battery
(negative earth)
Dimensions
Approx. 178 
×
 50 
×
 182 mm
(w/h/d)
Mounting dimensions
Approx. 182 
×
 53 
×
 160 mm
(w/h/d)
Mass
Approx. 1.5 kg
Supplied accessories
Parts for installation and
connections (1 set)
Front panel case (1)
Card remote commander
RM-X110 (US model)
RM-X111 (AEP, UK, E model)
Note
This unit cannot be connected to a digital preamplifier or an equalizer.
Design and specifications are subject to change without
notice.
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK
OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
breakdown because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic breakdown and also use
the procedure in the printed matter which is included in the repair
parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, when checking the laser diode emission, ob-
serve from more than 30 cm away from the objective lens.
Notes on Chip Component Replacement
Never reuse a disconnected chip component.
Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
If the optical pick-up block is defective, please replace the whole
optical pick-up block.
Never turn the semi-fixed resistor located at the side of optical
pick-up block.
US model:
AEP/UK model:
This label is located on the bottom of the chassis.
This label is located on the drive unit’s internal chassis.
When replacing the chassis (T) of mechanism deck which have
the “CAUTION LABEL” attached, please be sure to put a new
CAUTION LABEL (3-223-913-11) to the chassis (T).
CDX-M620/M670
Page of 77
Display

Click on the first or last page to see other CDX-M620 / CDX-M670 service manuals if exist.