Read Sony CDX-GT373A Service Manual online
CDX-GT373A
4
NOTE FOR REPLACEMENT OF THE SERVO BOARD
When repairing, the complete SERVO board (A-1201-631-A)
should be replaced since any parts in the SERVO board cannot be
repaired.
When repairing, the complete SERVO board (A-1201-631-A)
should be replaced since any parts in the SERVO board cannot be
repaired.
NOTE FOR THE 15-PIN CONNECTOR (CN901)
Do not use alcohol to clean the 15-pin connector (CN901) connect-
ing the front panel with the main body.
Do not touch the connector directly with your bare hand. Poor con-
tact may be caused.
Do not use alcohol to clean the 15-pin connector (CN901) connect-
ing the front panel with the main body.
Do not touch the connector directly with your bare hand. Poor con-
tact may be caused.
NOTE FOR REPLACEMENT OF THE AUX JACK (J901)
To replace the AUX jack requires alignment.
1. Insert the AUX jack into the KEY board.
2. Place the KEY board on the front panel.
3. Solder the three terminals of the jack.
To replace the AUX jack requires alignment.
1. Insert the AUX jack into the KEY board.
2. Place the KEY board on the front panel.
3. Solder the three terminals of the jack.
KEY board
front panel
AUX jack
please apply the HANARL SFL-9A
(Part No.7-400-000-00) to the
specified position.
(Part No.7-400-000-00) to the
specified position.
NOTE FOR REPLACEMENT OF THE FRONT PANEL
AND BUTTONS
When any of the following parts have been replaced, apply the
HANARL SFL-9A (Part No.7-400-000-00) to the specifi ed posi-
tion.
AND BUTTONS
When any of the following parts have been replaced, apply the
HANARL SFL-9A (Part No.7-400-000-00) to the specifi ed posi-
tion.
• PANEL (SV) ASSY
• LAVEL (SEEK)
• BUTTON (SOURCE)
• BUTTON (MODE)
• LAVER (BASE)
• BUTTON (INNER)
• LAVEL (SEEK)
• BUTTON (SOURCE)
• BUTTON (MODE)
• LAVER (BASE)
• BUTTON (INNER)
Click on the first or last page to see other CDX-GT373A service manuals if exist.