Read Sony CDX-GT360MP Service Manual online
CDX-GT360MP
4
KEY board
front panel
AUX jack
NOTE FOR REPLACEMENT OF THE SERVO BOARD
When repairing, the complete SERVO board (Part No.
A-1768-003-A) should be replaced since any parts in the SERVO
board cannot be repaired.
When repairing, the complete SERVO board (Part No.
A-1768-003-A) should be replaced since any parts in the SERVO
board cannot be repaired.
NOTE FOR REPLACEMENT OF THE AUX JACK (J901)
To replace the AUX jack requires alignment.
1. Insert the AUX jack into the KEY board.
2. Place the KEY board on the front panel.
3. Solder the three terminals of the jack.
To replace the AUX jack requires alignment.
1. Insert the AUX jack into the KEY board.
2. Place the KEY board on the front panel.
3. Solder the three terminals of the jack.
NOTE FOR THE 15-PIN CONNECTOR (CN901)
Do not use alcohol to clean the 15-pin connector (CN901) connect-
ing the front panel with the main body.
Do not touch the connector directly with your bare hand. Poor con-
tact may be caused.
Do not use alcohol to clean the 15-pin connector (CN901) connect-
ing the front panel with the main body.
Do not touch the connector directly with your bare hand. Poor con-
tact may be caused.
New/former discrimination:
Three kinds of following distinguish methods exist.
Three kinds of following distinguish methods exist.
• Distinguish method by serial number printed on the model
number label
– Main unit (Bottom side) –
Serial
number
Former type
New type
1548454 or smaller
1548455 or lager
• Distinguish method by Part No. printed on the KEY board
Former type : 1-884-598-11
New type
New type
: 1-884-598-21
– KEY Board (Side A) –
• Distinguish method by LCD driver IC (IC901) on the KEY
board
IC901
– KEY Board (Side B) –
Former type : LC75839
New type
New type
: PT6587-LQ
ABOUT CHANGE OF THE LCD DRIVER IC (IC901) ON
THE KEY BOARD
In this unit, the LCD driver IC (IC901) on the KEY board has been
changed in the midway of production.
The following changes are performed by this change.
THE KEY BOARD
In this unit, the LCD driver IC (IC901) on the KEY board has been
changed in the midway of production.
The following changes are performed by this change.
• Change of the KEY board (suffi x-21)
(Refer to supplement-1)
• Change of Part No. of the FRONT PANEL COMPLETE
ASSY (Refer to page 27)
• Change of Part No. of the MAIN board
(Refer to page 26 and 30)
• Change of part for Ref. No. IC501 on the MAIN board
(Refer to page 31)
Since all the above-mentioned change is synchronous change,
there is not compatibility of new type/former type in the front
panel side and main unit side.
Do the work after necessarily referring to following “New/former
discrimination”.
there is not compatibility of new type/former type in the front
panel side and main unit side.
Do the work after necessarily referring to following “New/former
discrimination”.
Note: When the parts of new front panel and the parts of former
main unit are combined, this unit does not operate nor-
mally.
mally.
Ver. 1.1
Click on the first or last page to see other CDX-GT360MP service manuals if exist.