Read Sony CDX-3150 Service Manual online
– 15 –
SECTION 3
ELECTRICAL ADJUSTMENTS
TEST MODE
This set have the test mode function. In the test mode, FM Auto Scan/
Stop Level and MW Auto Scan/Stop Level adjustments can be per-
formed easier than it in ordinary procedure.
Stop Level and MW Auto Scan/Stop Level adjustments can be per-
formed easier than it in ordinary procedure.
<Set the Test Mode>
1. Set the “OFF” mode.
2. Push the preset 4 button.
3. Push the preset 5 button.
4. Press the preset 1 button for more than two seconds.
5. Then the display indicates all lights, the test mode is set.
1. Set the “OFF” mode.
2. Push the preset 4 button.
3. Push the preset 5 button.
4. Press the preset 1 button for more than two seconds.
5. Then the display indicates all lights, the test mode is set.
<Release the Test Mode>
1. Push the OFF button.
1. Push the OFF button.
TUNER SECTION
Cautions during repair
When the tuner unit is defective, replace it by a new one because
its internal block is difficult to repair.
its internal block is difficult to repair.
Note on Adjustment
The adjustments of tuner section, should be performed according to
the following sequence.
1. FM Auto Scan/Stop Level Adjustment
2. FM Noise Focus Adjustment
3. FM Stereo Separation Adjustment
4. MW Auto Scan/Stop Level Adjustment
the following sequence.
1. FM Auto Scan/Stop Level Adjustment
2. FM Noise Focus Adjustment
3. FM Stereo Separation Adjustment
4. MW Auto Scan/Stop Level Adjustment
0 dB = 1 µV
FM Auto Scan/Stop Level Adjustment
Setting :
SOURCE button : FMI
FM RF signal
generator
0.01 µF
antenna
terminal
terminal
set
Carrier frequency : 98.0 MHz
Output level
Output level
: 22 dB (12.6 µV)
Mode
: mono
Modulation
: 1 kHz, 22.5 kHz deviation (30%)
Procedure :
1. Set to the test mode.
2. Push the SOURCE button and set to FMI.
1. Set to the test mode.
2. Push the SOURCE button and set to FMI.
Display
3. Push the preset 3 button.
Display
4. Adjust with the volume RV2 on TU1 so that the “FMI”
indication turns to “FMI I” indication on the display window.
But, in case of already indicated “FMI I”, turn the RV2 so that
put out light “I” indication and adjustment.
But, in case of already indicated “FMI I”, turn the RV2 so that
put out light “I” indication and adjustment.
Display
SHUFFLE
SHUFFLE
SHUFFLE
FM
I
FM
I
FM
I I
Adjustment Location : See page 17.
Click on the first or last page to see other CDX-3150 service manuals if exist.