Read Sony ZS-PS30CP Service Manual online
ZS-PS30CP
9
2-6. MAIN BOARD BLOCK
Note 1: Before disconnecting the fl exible fl at cable (16 core) of optical pick-up block, solder the short-land.
6
Solder the short-land.
Note 2: When assembling the MAIN
board block, remove the
solder of short-land after
connecting the flexible flat
cable (16 core).
cabinet (upper)
7
flexible flat cable (16 core)
8
flexible flat cable (6 core)
9
MAIN board block
MAIN board
front side
tape
3
connector
(S801)
4
two tapping screws
(BV
B2.6)
4
four tapping screws
(BV
B2.6)
4
tapping screw
(BV
B2.6)
1
tapping screw
(PWH
B2.6)
2
Remove ferrite core
from
rib.
ferrite core
Wire is below a screw hole. Wire is above a screw hole.
ferrite core
5
Remove the MAIN board block
in the direction of an arrow.
– Cabinet (upper) block bottom side view –
OK
NG
tape
:ire settinJ
Note 3: When installing the flexible
flat cable, ensure the coloured
line.
No slanting after insertion.
coloured line
coloured line
Insert is straight to the interior.
Insert is incline
flexible flat
cable
cable
flexible flat
cable
cable
connector
connector
OK
NG
Click on the first or last page to see other ZS-PS30CP service manuals if exist.