Read Sony ZS-M30 Service Manual online
25
ZS-M30
12. FOCUS BIAS CHECK
Change the focus bias and check the focus tolerance amount.
Change the focus bias and check the focus tolerance amount.
Checking Procedure:
1. Load the continuously-recorded disc. (Refer to “5. CREATING
1. Load the continuously-recorded disc. (Refer to “5. CREATING
CONTINUOUSLY-RECORDED DISC”)
2. Turn the JOG dial to display “CPLAY MODE”.
3. Press the YES/ENTER button twice to display “CPLAY
3. Press the YES/ENTER button twice to display “CPLAY
MID”.
4. Press the NO/CANCEL button when “C1 =
AD =
”
is displayed.
5. Turn the JOG dial to display “FBIAS CHECK”.
6. Press the YES/ENTER button to display “
6. Press the YES/ENTER button to display “
/
c =
”.
The first four digits indicate the C1 error rate, the two digits
after “ / ” indicate ADER, and the 2 digits after “c =” indicate
the focus bias value.
Check that the C1 error is below 50 and ADER is below 2.
after “ / ” indicate ADER, and the 2 digits after “c =” indicate
the focus bias value.
Check that the C1 error is below 50 and ADER is below 2.
7. Press the YES/ENTER button and display “
/
b =
”.
Check that the C1 error is about 200 and ADER is below 2.
8. Press the YES/ENTER button and display “
/
a =
”.
Check that the C1 error is about 200 and ADER is below 2.
9. Press the NO/CANCEL button, then press the Z (MD)
button and take out the disc.
Note 1:
If the C1 error and ADER are above other than the speci-
fied value at points A (step 8. in the above) or B (step 7. in
the above), the focus bias adjustment may not have been
carried out properly. Adjust perform the beginning again.
the above), the focus bias adjustment may not have been
carried out properly. Adjust perform the beginning again.
5-3. CD SECTION
Set the CD test mode when performing confirmations.
After completing the confirmation, release the CD test mode.
After completing the confirmation, release the CD test mode.
In the CD test mode, the set works as following sequence.
CD test mode sequence:
2.
CD
test mode 2
Press the
x
(CD) button
Press the
x
(CD) button
3. STOP mode 2
4. FOCUS mode
5. ALL SERVO
ON mode
6. LPC OFF
mode
7. TRACKING
GAIN UP mode
8. High speed
mode
Press the
u
(CD) button
Press the
u
(CD) button
Press the
x
(CD)
button.
Press the
u
,(CD)
button.
Press the
x
(CD)
button.
Press the
x
(CD)
button.
Press the
x
(CD)
button.
Press the
x
(CD)
button.
Press the
u
,(CD)
button.
Press the
u
,(CD)
button.
Press the
u
,(CD)
button.
Press the
u
,(CD)
button.
Press the
u
,(CD)
button.
1.
CD
test mode 1
Enter the
CD test mode
CD test mode
CD test mode
Click on the first or last page to see other ZS-M30 service manuals if exist.