Read Sony XDR-S16DBP Service Manual online
XDR-S16DBP
6
SECTION 4
DIAGRAMS
For Schematic Diagrams.
Note:
• All capacitors are in μF unless otherwise noted. (p: pF) 50
• All capacitors are in μF unless otherwise noted. (p: pF) 50
WV or less are not indicated except for electrolytics and
tantalums.
tantalums.
• All resistors are in Ω and 1/4 W or less unless otherwise
specifi ed.
•
C : Panel designation.
•
A : B+ Line.
• Voltages are dc with respect to ground under no-signal
(detuned) conditions.
no mark : TUNER (DAB/FM)
• Voltages are taken with VOM (Input impedance 10 M
• Voltages are taken with VOM (Input impedance 10 M
Ω).
Voltage variations may be noted due to normal production
tolerances.
• Signal path.
F
: TUNER (DAB/FM)
• Abbreviation
AUS : Australian model
AUS : Australian model
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
(In addition to this, the necessary note is printed in each block.)
For Printed Wiring Boards.
Note:
•
•
X : Parts extracted from the component side.
•
Y : Parts extracted from the conductor side.
•
: Pattern from the side which enables seeing.
(The other layers’ patterns are not indicated.)
• Circuit Boards Location
MAIN board
MODULE (DAB TUNER)
JACK (DC) board
JACK (HEADPHONE) board
VOLUME board
KEY board
SECTION 3
TEST MODE
LCD TEST MODE
Procedure:
1. In the power off status, press three buttons of [DISPLAY],
Procedure:
1. In the power off status, press three buttons of [DISPLAY],
[MENU] and [ENTER] for 5 seconds.
2. All segments on the liquid crystal display light up.
Releasing method:
To release the LCD test mode, press the [POWER] button.
To release the LCD test mode, press the [POWER] button.
Click on the first or last page to see other XDR-S16DBP service manuals if exist.