TC-WE475 (serv.man4) - Sony Audio Service Manual (repair manual). Page 2

2

-Component side-

1-672-707-31
1-685-972-12
1-685-972-13

Former type :

New type :

or

 

A-2100-941-A

A-2100-941-B

A-2100-942-A

A-2100-942-B

Refer to the label on the motor

UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size.)

Unleaded solder has the following characteristics.

• Unleaded solder melts at a temperature about 40

°C higher than

ordinary solder.

Ordinary soldering irons can be used but the iron tip has to be

applied to the solder joint for a slightly longer time.

Soldering irons using a temperature regulator should be set to

about 350

°C.

Caution: The printed pattern (copper foil) may peel away if

the heated tip is applied for too long, so be careful!

• Strong viscosity

Unleaded solder is more viscous (sticky, less prone to flow)

than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.

• Usable with ordinary solder

It is best to use only unleaded solder but unleaded solder may

also be added to ordinary solder.

NEW TYPE  IDENTIFICATION
Please see the part code of the main board or the part code of the mechanism deck and distinguish former type or new type of the set.