Read Sony STR-DH810 Service Manual online
STR-DH810
2
NOTES ON CHIP COMPONENT REPLACEMENT
•
•
Never reuse a disconnected chip component.
•
Notice that the minus side of a tantalum capacitor may be
damaged by heat.
damaged by heat.
SAFETY CHECK-OUT
After correcting the original service problem, perform the follow-
ing safety check before releasing the set to the customer:
Check the antenna terminals, metal trim, “metallized” knobs,
screws, and all other exposed metal parts for AC leakage.
Check leakage as described below.
After correcting the original service problem, perform the follow-
ing safety check before releasing the set to the customer:
Check the antenna terminals, metal trim, “metallized” knobs,
screws, and all other exposed metal parts for AC leakage.
Check leakage as described below.
LEAKAGE TEST
The AC leakage from any exposed metal part to earth ground and
from all exposed metal parts to any exposed metal part having a
return to chassis, must not exceed 0.5 mA (500 microamperes.).
Leakage current can be measured by any one of three methods.
1. A commercial leakage tester, such as the Simpson 229 or RCA
The AC leakage from any exposed metal part to earth ground and
from all exposed metal parts to any exposed metal part having a
return to chassis, must not exceed 0.5 mA (500 microamperes.).
Leakage current can be measured by any one of three methods.
1. A commercial leakage tester, such as the Simpson 229 or RCA
WT-540A. Follow the manufacturers’ instructions to use these
instruments.
instruments.
2. A battery-operated AC milliammeter. The Data Precision 245
digital multimeter is suitable for this job.
3. Measuring the voltage drop across a resistor by means of a
VOM or battery-operated AC voltmeter. The “limit” indication
is 0.75 V, so analog meters must have an accurate low-voltage
scale. The Simpson 250 and Sanwa SH-63Trd are examples
of a passive VOM that is suitable. Nearly all battery operated
digital multimeters that have a 2 V AC range are suitable. (See
Fig. A)
is 0.75 V, so analog meters must have an accurate low-voltage
scale. The Simpson 250 and Sanwa SH-63Trd are examples
of a passive VOM that is suitable. Nearly all battery operated
digital multimeters that have a 2 V AC range are suitable. (See
Fig. A)
1.5 k
Ω
0.15
μF
AC
voltmeter
(0.75 V)
voltmeter
(0.75 V)
To Exposed Metal
Parts on Set
Parts on Set
Earth Ground
Fig. A. Using an AC voltmeter to check AC leakage.
SAFETY-RELATED COMPONENT WARNING!
COMPONENTS IDENTIFIED BY MARK
0 OR DOTTED LINE
WITH MARK
0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS
REPLACE THESE COMPONENTS WITH SONY PARTS
WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS
MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
About area codes
The area code of the receiver you purchased is
shown on the lower right portion of the rear panel
(see the illustration below).
shown on the lower right portion of the rear panel
(see the illustration below).
Any differences in operation, according to the area
code, are clearly indicated in the text, for example,
“Models of area code AA only”.
code, are clearly indicated in the text, for example,
“Models of area code AA only”.
IN 1
TV OUT
ARC
BLE (INPUT ONLY)
L
R
L
R
SURROUND
FRONT A
4-XXX-XXX-XX(X) AA
Area code
Video section
Inputs/Outputs
Video:
Inputs/Outputs
Video:
1 Vp-p, 75 ohms
COMPONENT VIDEO:
Y: 1 Vp-p, 75 ohms
P
B
/C
B
: 0.7 Vp-p, 75 ohms
P
R
/C
R
: 0.7 Vp-p, 75 ohms
80 MHz HD Pass Through
General
Power requirements
Power requirements
Area code
Power requirements
AEP, UK
230 V AC, 50/60 Hz
US
120 V AC, 60 Hz
AUS
230 V AC, 50 Hz
Power output (DIGITAL MEDIA PORT)
DC OUT:
DC OUT:
5V, 0.7 A MAX
Power consumption
Area code
Power consumption
AEP, UK, US, AUS 240 W
Dimensions (width/height/depth) (Approx.)
430 mm × 157.5 mm ×
322 mm (17 in × 6 1/4 in ×
12 3/4 in) including projecting
parts and controls
322 mm (17 in × 6 1/4 in ×
12 3/4 in) including projecting
parts and controls
Mass (Approx.)
Models of area code AEP, UK, AUS
Models of area code AEP, UK, AUS
8.2 kg (18 lb 2 oz)
Models of area code US
7.9 kg (17 lb 7 oz)
Supplied accessories
• Operating instructions
• Quick Setup Guide
• FM wire antenna (aerial) (1)
• Operating instructions
• Quick Setup Guide
• FM wire antenna (aerial) (1)
• AM loop antenna (aerial) (1)
• Remote commander (1)
- RM-AAP049 (Models of area code US only)
- RM-AAP050 (Models of area code AEP, UK,
- RM-AAP049 (Models of area code US only)
- RM-AAP050 (Models of area code AEP, UK,
AUS only)
• R6 (size-AA) batteries (2)
• Optimizer microphone (ECM-AC2) (1)
Design and specifi cations are subject to change
without notice.
without notice.
• Standby power consumption: 0.3 W
• Halogenated fl ame retardants are not used in the
• Halogenated fl ame retardants are not used in the
certain printed wiring boards.
Ver. 1.1
Click on the first or last page to see other STR-DH810 service manuals if exist.