Read Sony STR-DH130 Service Manual online
13
13
STR-DH130
STR-DH130
For Schematic Diagrams.
Note:
• All capacitors are in μF unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics
• All capacitors are in μF unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in
and
1
/
4
W or less unless otherwise
specifi ed.
• f : internal component.
• 2 : nonfl ammable resistor.
• 2 : nonfl ammable resistor.
• 5 : fusible resistor.
• C : panel designation.
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
(In addition to this, the necessary note is printed in each block.)
• A : B+ Line.
• B : B– Line.
• Voltages and waveforms are dc with respect to ground
• B : B– Line.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : FM
• Voltages are taken with VOM (Input impedance 10 M
• Voltages are taken with VOM (Input impedance 10 M
).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveform.
• Signal path.
d
d
:
ANTENNA
(FM/AM)
F
:
AUDIO
• Abbreviation
CND : Canadian model
CND : Canadian model
For Printed Wiring Boards.
Note:
• X : Parts extracted from the component side.
• f : internal component.
•
• X : Parts extracted from the component side.
• f : internal component.
•
: Pattern from the side which enables seeing.
Caution:
Parts face side:
(SIDE A)
Pattern face side:
(SIDE B)
Parts face side:
(SIDE A)
Pattern face side:
(SIDE B)
Parts on the parts face side seen from
the parts face are indicated.
Parts on the pattern face side seen
from the pattern face are indicated.
the parts face are indicated.
Parts on the pattern face side seen
from the pattern face are indicated.
Note:
The components identi-
fi
The components identi-
fi
ed by mark 0 or dotted
line with mark 0 are
critical for safety.
Replace only with part
number specifi ed.
critical for safety.
Replace only with part
number specifi ed.
Note:
Les composants identifi és
par une marque 0 sont
critiques pour la sécurité.
Ne les remplacer que par
une piéce portant le nu-
méro spécifi é.
Les composants identifi és
par une marque 0 sont
critiques pour la sécurité.
Ne les remplacer que par
une piéce portant le nu-
méro spécifi é.
• Abbreviation
CND : Canadian model
CND : Canadian model
• Waveforms
– MAIN Board –
243.3 mVp-p
8 MHz
1
IC702 qd (X313(XOUT))
100 mV/DIV, 50 nsec/DIV
Click on the first or last page to see other STR-DH130 service manuals if exist.