Read Sony STR-DB900 Service Manual online
11
STR-DB900
Note on Schematic Diagram:
• All capacitors are in
• All capacitors are in
µ
F unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics and
tantalums.
tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
• %
: indicates tolerance.
•
f
: internal component.
•
2
: nonflammable resistor.
•
C
: panel designation.
•
A
: B+ Line.
•
B
: B– Line.
• Voltages and waveforms are dc with respect to ground un-
der no-signal conditions.
No mark : FM
No mark : FM
*
: Impossible to measure
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal production
tolerances.
tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production
tolerances.
tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: FM
g
: VIDEO
• Abbreviation
SP
: Singapore model
MY
: Malaysia model
NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
(In addition to this necessary note is printed in each block.)
(In addition to this necessary note is printed in each block.)
Note on Printed Wiring Board:
•
•
X
: parts extracted from the component side.
•
a
: Through hole.
•
: Pattern from the side which enables seeing.
• Abbreviation
SP
: Singapore model
MY
: Malaysia model
Caution:
Pattern face side: Parts on the parts face side seen from
(Side A)
Pattern face side: Parts on the parts face side seen from
(Side A)
the parts face are indicated.
Parts face side:
Parts on the pattern face side seen from
(Side B)
the pattern face are indicated.
Note: The components identified by mark
0
or dotted
line with mark
0
are critical for safety.
Replace only with part number specified.
Click on the first or last page to see other STR-DB900 service manuals if exist.