Read Sony STR-DA90ESG Service Manual online
– 7 –
SECTION 3
ELECTRICAL ADJUSTMENTS
ON SCREEN SECTION
OSD ADJUSTMENT
Setting:
Monitor TV
Vectroscope
VIDEO output terminal
SET
VIDEO 1 S terminal
S. VIDEO SG
Procedure:
1. Connect the frequency counter to R813.
2. Turn the POWER switch ON, press VIDEO 1 and set the func-
1. Connect the frequency counter to R813.
2. Turn the POWER switch ON, press VIDEO 1 and set the func-
tion to VIDEO 1. (The input signal set to OFF.)
3. Turn the POWER switch OFF, keep the BAND ,
buttons
depressed at the same time and then turn the POWER switch
ON.
ON.
4. Check that the screen shown only the color bars, and then ad-
just CT802 so that the reading becomes 3.5796 MHz ± 10 kHz.
5. Adjust CT801 so that the right edge of the color bars on the
screen comes within the frame.
BLA
CK
RED
BLUE
D
ARK GRA
Y
GRA
Y
ORANGE
GREEN
WHITE
Center
a=b
(Picture of monitor screen)
a
b
6. The input signal set to ON.
BLA
CK
(THR
OUGH)
BLUE
D
ARK GRA
Y
GRA
Y
(THR
OUGH)
GREEN
WHITE
R813
CT802
IC814
RV801 CT801
CT803
IC805
Frequency counter
7. Turn the POWER switch OFF, keep the BAND ,
buttons
depressed at the same time and then turn the POWER switch
ON.
ON.
8. Adjust the picture frame as shown in (picture of monitor screen)
when using a color bar chart for adjustment with RV801.
INITIALIZATION OF THE MICROCOMPUTER
KEEP the DISPLAY , OPEN/CLOSE buttons depressed simul-
taneously and then turn the POWER switch ON.
taneously and then turn the POWER switch ON.
Adjustment Location: VIDEO board (Component side)
Click on the first or last page to see other STR-DA90ESG service manuals if exist.