Read Sony SRF-HM03V Service Manual online
3
SRF-HM03V
SECTION 1
GENERAL
This section is extracted from
instruction manual.
instruction manual.
POWER ON/OFF
Driver Unit
TUNE +*
2
/—
Display
MEGA BASS/CLOCK
ENTER
MODE
BAND
VOL*
1
TV/WB/FM SENS
DX/LOCAL
DX/LOCAL
R (Right)
L (Left)
Battery
compartment lid
compartment lid
Light reflector (L)
This reflector
reflects car lights
at night for your
safety.
This reflector
reflects car lights
at night for your
safety.
*
1
There is a tactile dot beside volume to show the
direction to turn up the volume.
direction to turn up the volume.
*
2
The TUNE + button has a tactile dot.
Setting the Clock
The clock time display of this unit is a 12-hour system.
When the battery is first installed, AM 12:00 flashes in the display.
When the battery is first installed, AM 12:00 flashes in the display.
1
Set POWER to OFF to turn off the power.
2
Hold down MEGA BASS/CLOCK for more than 2 seconds
until AM 12 starts flashing.
until AM 12 starts flashing.
3
Press TUNE + or – to adjust the hour, then press MEGA BASS/
CLOCK.
CLOCK.
If you hold down
TUNE + or —, the digit changes rapidly.
AM 12:00 = midnight, PM 12:00 = noon.
4
Repeat step 3 above to adjust the minute.
: starts flashing and the clock starts operating.
To set the current time exactly to the second, adjust the minute and then press
MEGA BASS/CLOCK to synchronize with a time signal (such as the
telephone time signal).
MEGA BASS/CLOCK to synchronize with a time signal (such as the
telephone time signal).
Note
If you do not press
If you do not press
TUNE + or —, or MEGA BASS/CLOCK within one minute,
the clock setting mode will be canceled.
Wearing the Headphone
Radio
Radio
(See fig
A)
1
Wear the
L side driver unit in your left ear and the R side in your
right ear as illustrated.
2
Adjust the position of the driver units for a comfortable fit.
Changing AM Channel Step
The AM channel step differs depending on areas. The channel step of this unit is
factory-set to 10 kHz. Change the settings as shown below to be able to listen to
the radio.
factory-set to 10 kHz. Change the settings as shown below to be able to listen to
the radio.
Area
Channel step
North and South American countries
10 kHz
Other countries
9 kHz
Note
When the AM channel step is changed, only the preset stations on the AM band
will be initialized.
When the AM channel step is changed, only the preset stations on the AM band
will be initialized.
1
Set POWER to OFF to turn off the power.
2
While holding down MODE, hold down TUNE + or – for more
than 5 seconds.
than 5 seconds.
The channel step will change and 9 kHz (or 10 kHz) will flash for 3
seconds in the display.
If you proceed to step
seconds in the display.
If you proceed to step
2 again, the channel step changes again.
Light reflector (R)
A
Click on the first or last page to see other SRF-HM03V service manuals if exist.