SPK-HCD - Sony Audio Service Manual (repair manual)

2008K0200-1

  ©2008.11

SPK-HCD

US Model

Canadian Model

AEP Model

Revised-1

Replace the previously issued
SERVICE MANUAL 9-852-243-11
with this Manual.

Plastic (PC, ABS)
glass

O-ring, buckles

Stereo

Approx. 159 

× 148 × 220 mm (w / h / d) (6 3/8 × 5 7/8  × 8 3/4 inches)

Approx. 960 g (2 lb 2 oz) (only sports pack)

Sports pack (1)
Shoulder strap (1)
Camera mounting shoe (B (1)/D (1)/E (1)/F (1)/G (1)/H (1)/I (1))
Tripod screw plate (1)
Reflex prevention ring (Ø 25 (1)/M30 

× Ø 43 (1)/M30 × Ø 50 (1)/

 M30 

× Ø 58 (1)/M30 × Ø 62 (1)/M37 × Ø 55 (1))

Grease (1)
Spacer (1)
Anti-fogging lens solution (1)
Desiccant (1)
Set of printed documentation

Design and specifications subject to change without notice.

• This Sports Pack SPK-HCD is exclusively for use with the Sony digital

video camera recorder HDR-SR12/SR11/SR10/SR8/SR7/SR5, HDR-CX7/
CX6, HDR-UX20/UX19/UX10/UX9/UX7/UX5/UX3,
HDR-HC9/HC7/HC5/HC3,
DCR-SR300/SR290/SR220/SR210/SR200/SR190/SR85/SR82/SR75/SR72/
SR65/SR62/SR55/SR52/SR46/SR45/SR42/SR36/SR35/SR33/SR32,
DCR-DVD910/DVD908/DVD810/DVD808/DVD803/DVD710/DVD708/
DVD703/DVD653/DVD610/DVD608/DVD602/DVD510/DVD508/
DVD506/DVD410/DVD408/DVD406/DVD403/DVD310/DVD308/
DVD306/DVD203/DVD202/DVD115/DVD110/DVD109/DVD108/
DVD106/DVD103/DVD92,
DCR-HC96/HC94/HC62/HC54/HC53/HC52/HC51/HC48/HC47/HC46/
HC45/HC44/HC38/HC37/HC36/HC35/HC28/HC27/HC26/HC24/HC23

* The above video camera models may not be available in all countries/regions.

• The sports pack SPK-HCD is water- and moisture- resistant, making it

possible to use the Sony digital video camera recorder (referred to below as
“video camera”).

• Usable at the depth as low as 5 meters (17 feet) under water.
• For using your video camera with this sports pack, refer to the operating

instructions of the video camera.

• Before you start recording, make sure that the video camera is working

correctly and there is no water leakage.

• Sony does not accept liability for damage to the video camera, battery,

etc., when using the sports pack or for the cost of recording if water
leakage occurs as a result of incorrect use.

— 2 —

SPK-HCD

0

0

0

1.

Check the area of your repair for unsoldered or poorly-soldered
connections.  Check the entire board surface for solder splashes
and bridges.

2.

Check the interboard wiring to ensure that no wires are
"pinched" or contact high-wattage resistors.

3.

Look for unauthorized replacement parts, particularly
transistors, that were installed during a previous repair.  Point
them out to the customer and recommend their replacement.

4.

Look for parts which, through functioning, show obvious signs
of deterioration.  Point them out to the customer and
recommend their replacement.

5.

Check the B+ voltage to see it is at the values specified.

6.

Flexible Circuit Board Repairing

• Keep the temperature of the soldering iron around 270˚C

during repairing.

• Do not touch the soldering iron on the same conductor of the

circuit board (within 3 times).

• Be careful not to apply force on the conductor when soldering

or unsoldering.

After correcting the original service problem, perform the following

safety checks before releasing the set to the customer.

EXPLODED VIEWS
1.

OVERALL SECTION ·························································· 3

2.

FRONT CASE SECTION ···················································· 4

3.

SUPPLIED ACCESSORIES ················································ 5

— 3 —

SPK-HCD

NOTE:

•

-XX, -X mean standardized parts, so they may
have some differences from the original one.

•

Items marked “*” are not stocked since they
are seldom required for routine service. Some
delay should be anticipated when ordering these
items.

•

The mechanical parts with no reference number
in the exploded views are not supplied.

Ref. No.

Part No.

Description

Ref. No.

Part No.

Description

Note :
The marked  “

0

”  are parts in

relation to waterproof.
Replace these components with
Sony parts.
Be sure to check up waterproof
after repair.

Note :
La 

0

 marquée sont des pièces par

rapport à imperméable à l’ eau.
Ne les remplacer que par une
pièce portant le numéro spécifié.
Soyez sûr de vérifier vers le haut
d’ imperméable à l’ eau après la
réparation.

ns : not supplied

ns

ns

ns

(Note 1)

(Note 2)

(See page 4)

1

2-580-983-01 SHAFT, HINGE

2

3-098-142-01 CASE, REAR

0 3

3-098-143-01 O RING, MAIN (Note 1)

4

A-1510-962-A HOOD ASSY, MIRROR

5

2-580-955-01 MIRROR (Note 2)

6

2-580-954-01 HOOD, MIRROR

7

2-580-969-01 SHAFT, BUCKLE

8

2-589-138-01 RETAINER, GRIP

9

3-076-866-01 BIND (2X6), TAPPING SCREW

10

A-1105-402-A GRIP BELT ASSY

11

2-634-715-01 TUBE, GRIP BELT

12

2-580-957-01 BUCKLE

13

3-951-813-11 SCREW (2X6) (TYPE 2), +K

0 14

3-073-881-01 CAP (RED), AIR PUNCHING

15

2-580-959-01 KNOB, BUCKLE SLIDER

16

2-589-297-01 LOCK, BUCKLE

17

2-589-298-01 SPRING, BUCKLE LOCK

18

2-593-190-01 SLIDER (LOWER), BUCKLE

19

2-651-030-01 SPRING, SLIDER

20

2-580-958-01 SLIDER, BUCKLE

21

2-580-961-01 PLATE, BUCKLE RETAINER

22

3-052-424-01 SHAFT, GRIP

23

2-580-956-01 SHAFT, MIRROR HINGE

(Note 1): When putting grease the main O-ring (Ref. No. 3),

always use the grease of the blue tube of the accessory.
When using the grease of the yellow tube and the grease of
the other Inc., it hurts the main O-ring and it causes the water
leakage.

(Note 2): To prevent the wound under transportation, the protection

seat is pasted to the repair parts of mirror.
Please exchange mirror after peeling off this protection seat at
the repair.

— 4 —

SPK-HCD

Ref. No.

Part No.

Description

Ref. No.

Part No.

Description

51

3-076-866-01 BIND (2X6), TAPPING SCREW

52

A-1510-965-A SPK001 BOARD, COMPLETE (Note 2)

53

2-668-979-01 BOX, CONTROL

54

(Note 1)

HIMERON

* 55

3-959-469-01 PLATE, TRIPOD SCREW

56

3-091-040-01 SCREW (2.6X6), TAPPING

57

2-668-974-01 LENS (WINDOW RETAINER)

58

2-668-987-01 GLASS, LENS WINDOW

0 59

2-668-986-01 PACKING, LENS WINDOW (Note 3)

0 60

A-1510-964-A CASE ASSY, FRONT

0 61

A-7095-209-A MICROPHONE BLOCK ASSY

62

2-668-993-01 COVER, CODE

63

2-668-975-01 COVER, LENS WINDOW

64

2-668-977-01 COVER, MICROPHONE

65

2-593-204-01 LABEL, TEMPERATURE CAUTION

66

3-295-028-01 COVER, CONTROL

67

1-830-399-21 CORD, CONNECTION (AV MULTIPLE)

68

A-1510-963-A BASE (H) BLOCK ASSY

69

X-2048-702-1 BASE ASSY, SCREW

70

2-589-173-01 RING (DIA. 1.5), E

ns : not supplied

(Note 2) In this model, parts are exchange in order to repair only the

mounted board.

Note :
The marked  “

0

”  are parts in

relation to waterproof.
Replace these components with
Sony parts.
Be sure to check up waterproof
after repair.

Note :
La 

0

 marquée sont des pièces par

rapport à imperméable à l’ eau.
Ne les remplacer que par une
pièce portant le numéro spécifié.
Soyez sûr de vérifier vers le haut
d’ imperméable à l’ eau après la
réparation.

(Note 3) When putting grease the lens window packing (Ref. No. 59),

always use the grease of the blue tube of the accessory.
When using the grease of the yellow tube and the grease of the
other Inc., it hurts the lens window packing and it causes the
water leakage.

SP

K

-00

1

ns

ns

ns

ns

(Note 3)

(SIZE : 12mm 

×

 38mm)

(Note 2)

(Note 1)

(SIZE : 6.5mm 

×

 10mm)

(Note 1)

(Note 1) For the part of 54: HIMERON, Cut the NON WOVEN (T0.25)

(3-076-631-01) for specified size.