Read Sony SA-WSLF10 / SS-CTL10 / SS-TSL10 / SS-TSL11 Service Manual online
4
SA-WSLF10/SS-CTL10/TSL10/TSL11
THE CHECK METHOD OF THE OUTPUT SIGNAL FROM TX BOARD
Procedure:
1. A spectrum analyzer is connected to pin 1 and pin 2 of the output connector (CN803) of TX board.
2. Confirm that it is spectrum as shown in a figure with the spectrum analyzer. It is normal if the signal of a 3MHz to 6MHz zone (a center
is 4.5MHz) can be checked.
digital
voltmeter
10
Ω
(0.5%)
TX board
CN803 pin
1
pin
2
3. When the output signal from TX board is normal, pin 8 (SDATA), pin 4 (LRCKO) and pin 5 (BCKO) of the input signal connector
(CN801) are investigated.
Super audio CD/
DVD player :
HCD-LF10
DVD player :
HCD-LF10
Units required for
operation
check
Super audio CD/
DVD player : HCD-LF10
DVD player : HCD-LF10
Sub woofer :
SA-WSLF10
SA-WSLF10
Front speaker :
SS-TSL10
SS-TSL10
Center speaker :
SS-CTL10
SS-CTL10
Surround speaker :
SS-TSL11
SS-TSL11
Remote commander :
RM-SP320
RM-SP320
Unit.
need to
checking
need to
checking
a
a
a
Center
speaker :
SS-CTL10
speaker :
SS-CTL10
a
a
Sub woofer :
SA-WSLF10
SA-WSLF10
a
a
a
a
Remote
commander :
RM-SP320
commander :
RM-SP320
IR transmitter :
DIR-T1
DIR-T1
Remote
sensor :
DIR-R4
sensor :
DIR-R4
Surround
amplifier :
TA-SB500WR
amplifier :
TA-SB500WR
IR receiver :
DIR-R1
DIR-R1
a
a
a
a
a
a
a
a
a
a
a
a
Surround
speaker :
SS-TSL11
speaker :
SS-TSL11
a*
1
Front speaker :
SS-TSL10
SS-TSL10
a*
1
a*
2
*
1 Only the defective unit.
*
2 Either one of them.
Units with
a
mark: The units that are required for the system operation check during repair service
However, there can be a case that some units of the system need to not be brought into repair shop depending on the unit. that became defective.
• The units that are required for the system operation check during repair service
Click on the first or last page to see other SA-WSLF10 / SS-CTL10 / SS-TSL10 / SS-TSL11 service manuals if exist.