Read Sony SA-WM200 Service Manual online
3
3
SA-WM200
SECTION 1
GENERAL
This section is extracted from
instruction manual.
instruction manual.
LEVEL
PHASE
POWER
POWER indicator
CUT OFF FREQ
CUT OFF FREQ
200H z
NORMAL
REVERS E
50H z
PHASE
POWER
LEVEL
MIN
MAX
FRONT VIEW
REAR VIEW
• Location of controls
SECTION 2
DIAGRAMS
For Schematic Diagrams.
Note:
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF 50 WV or
less are not indicated except for electrolytics and tantalums.
• All resistors are in Ω and
1
/
4
W or less unless otherwise specified.
• C : panel designation.
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
(In addition to this, the necessary note is printed in each block.)
For Printed Wiring Boards.
Note :
Note :
• X : parts extracted from the component side.
• x : parts extracted from the conductor side.
•
• x : parts extracted from the conductor side.
•
: Pattern from the side which enables seeing.
• Abbreviation
CND : Canadian model
MY
MY
: Malaysia model
SP
: Singapore model
• A : B+ Line.
• B : B– Line.
• Voltages are dc with respect to ground under no-signal conditions.
• no mark : Power on
• Voltages are taken with a VOM (Input impedance 10 MΩ).
• B : B– Line.
• Voltages are dc with respect to ground under no-signal conditions.
• no mark : Power on
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal production tolerances.
• Signal path
.
F
: AUDIO
• Abbreviation
CND : Canadian model
MY
MY
: Malaysia model
SP
: Singapore model
Note:
The components identi-
fied by mark 0 or dotted
line with mark 0 are criti-
cal for safety.
Replace only with part
number specified.
The components identi-
fied by mark 0 or dotted
line with mark 0 are criti-
cal for safety.
Replace only with part
number specified.
Note:
Les composants identifiés par
une marque 0 sont critiques
pour la sécurité.
Ne les remplacer que par une
piéce portant le numéro
spécifié.
Les composants identifiés par
une marque 0 sont critiques
pour la sécurité.
Ne les remplacer que par une
piéce portant le numéro
spécifié.
2-1. CIRCUIT BOARDS LOCATION
SWITCH board
INPUT CONTROL board
MAIN board
POWER TRANS board
CONTROL board
Click on the first or last page to see other SA-WM200 service manuals if exist.