Read Sony SA-WCT660 Service Manual online
SA-WCT660
10
2-9. SUB MAIN BOARD
qa three claws
qs RF modulator block
qd SUB MAIN board
7 two screws
(BV3)
9 three screws
(BV3)
5 connector
(CN
901
)
4 connector
(CN
106
)
3 Remove two wires
from lead pin.
0 Remove the SUB MAIN board
block in the direction of an arrow.
– Sub AMP block rear view –
1 screw (BV3)
2 lug wire
lug wire
SUB MAIN board
lead pin
:ire VeWWiQJ
SUB MAIN board
Note 1: When installing the flexible flat cable, ensure the colored
line. No slanting after insertion.
colored line
colored line
Insert is straight to the interior.
Insert is incline
flexible flat
cable
cable
flexible flat
cable
cable
connector
connector
OK
NG
8 heat sink (AMP)
Note
2: When installing the heat sink (AMP),
spread the compound referring to
“NOTE OF REPLACING THE IC104
ON
THE
SUB MAIN BOARD AND
THE COMPLETE SUB MAIN BOARD”
on servicing notes (page 3).
terminal
face
face
6 flexible flat cable (24 core) (CN107)
Note
3: When installing the flexible flat cable (24 core),
insert in the correct orientation after confirming
the terminal face.
Click on the first or last page to see other SA-WCT660 service manuals if exist.