Read Sony NW-S202 / NW-S202F / NW-S203F / NW-S205F (serv.man2) Service Manual online
NW-S202/S202F/S203F/S205F
2
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
For Printed Wiring Boards.
Note:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• f : internal component.
•
• Y : parts extracted from the conductor side.
• f : internal component.
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
• MAIN board is multi-layer printed board.
However, the patterns of intermediate-layer have not been
However, the patterns of intermediate-layer have not been
included in diagram.
• Lead Layouts
For Schematic Diagrams.
Note:
• All capacitors are in µF unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics and
50 WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in Ω and 1/4 Ω or less unless otherwise
specified.
• f : internal component.
• C : panel designation.
• C : panel designation.
• A : B+ Line.
• Power voltage is dc 3.7 V and fed with regulated dc power
• Power voltage is dc 3.7 V and fed with regulated dc power
supply from CN601 pin 1 and pin 2 on the MAIN board.
• Voltages are dc with respect to ground under no-signal
conditions.
no mark: PLAYBACK
• Voltages are taken with a VOM (Input impedance 10 MΩ).
• Voltage variations may be noted due to normal production
• Voltages are taken with a VOM (Input impedance 10 MΩ).
• Voltage variations may be noted due to normal production
tolerances.
• Signal path.
F
F
: AUDIO
• The voltage and waveform of CSP (chip size package)
cannot be measured, because its lead layout is different
from that of conventional IC.
from that of conventional IC.
* Replacement of IC101 and IC201 on the MAIN board
used in this set requires a special tool.
* Replacement of IC101 and IC201 on the MAIN board
used in this set requires a special tool.
Caution:
Pattern face side: Parts on the pattern face side seen from
(Side B)
(Side B)
the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(Side A)
(Side A)
the parts face are indicated.
surface
Lead layout of conventional IC
CSP (chip size package)
2. DIAGRAMS
Click on the first or last page to see other NW-S202 / NW-S202F / NW-S203F / NW-S205F (serv.man2) service manuals if exist.