Read Sony NW-E10 / NW-E7 Service Manual online
4
NW-E7/E10
Ver 1.1 2002.01
Work Procedure
Preparation:
1. Make sure that no battery is loaded in the set.
2. Start up the test mode “appllo_service. exe” of the service tool (J-2507-037-1 ) from the PC, and check that the following screen
appears.
1. Make sure that no battery is loaded in the set.
2. Start up the test mode “appllo_service. exe” of the service tool (J-2507-037-1 ) from the PC, and check that the following screen
appears.
3. Connect PC to this set with a USB cable. Check that the block 1 of the following screen “open”, and “1PC” is displayed on
the LCD of the set. (The block 1 will “close” if the set is disconnected again) At this time, a sine wave is outputted from the
headphone. Also, the model name is displayed in the block qd of the screen.
headphone. Also, the model name is displayed in the block qd of the screen.
Note: If the block 1 does not “open”, the circuits in MAIN board will be faulty. Audio signals are outputted from
the reference signal in the DSP of the set.
Click on the first or last page to see other NW-E10 / NW-E7 service manuals if exist.