NW-E10, NW-E7 - Sony Audio Service Manual (repair manual). Page 3

3

This document describes the “operation check for inspection (Test mode)” and “adjustment after board replacement for repair”.
In performing these works, connect this set to the PC via a USB cable and use the following tool.

1. In performing the work, the set should be in a complete state (all components assembled).
2. Install the “OpenMG Jukebox” and “WMP7 Plug-in” (CD-ROM) in the PC in advance.
3. Do not start up other applications in the PC.
4. This set has the Test mode, and various functions can be checked by using exclusive application (Service Tool) on the PC side.
5. Be sure to replace the MAIN board, if any part listed in Table 1-1 is faulty.
6. The data in Table 1-2 have been written to the MAIN board.
7. In repairing other than above parts, repair as usual.

Ref. No

1

Tool name

Service tool 9140 (FD)

Part code

J-2507-037-1

Application

Board check (Test mode) and readjustment after board replacement

Board name

MAIN board

Ref. No

IC601, IC602, IC603, IC901

Board name

MAIN board

Stored date

Music date, Equalizer initial values, CODEC programs, and ID/IK codes

1. Be sure to remove the battery from this set. (The power is supplied via USB cable) Operating the set in the Test mode with the battery

loaded could clear necessary information.

2. If operation check was performed for inspection, execute “Play Info Initialize” in qd (see page 7) to return respective functions to

initial positions (see Table 1-5 on page 7). In such a case, record current position of each function before executing “Play Info
Initialize” in qd , if necessary.