NAS-S55HDE, NAS-SC55PKE, SS-S55HDE - Sony Audio Service Manual (repair manual). Page 6

HOW  TO  DRAW  OUT  FORCIBLY  THE  DISC  TRAY
In the event that the disc tray does not come out due to any fail-
ure, three methods are available to draw it out forcibly. Use either 
method described below according to the symptom.

METHOD  1
If the power did not turn on or if the power is OFF:
1.  With the power cord unplugged, remove the panel (side L) / 

(side R) assembly, panel (top), and panel (front). (See “How to 
Remove 2-2, 2-3 (page 8), 2-6 (page 10)”)

2.  As shown in the fi gure, insert a thin rod into the hole at the 

lower part of CD block, and push it in the arrow A direction.

"

Insert a thin rod into the 
hole and push it in the 
arrow " direction.

METHOD  2
If the CD-ROM drive is turned on but the mother board does not 
start:
1.  Insert a thin fl at-tip screwdriver into a round hole at the bottom 

of the set.

2.  Through a hole at the bottom of CD-ROM drive, short the 

points (patterns) on the board of CD-ROM drive.

METHOD  3
If the mother board starts but the system software is abnormal:
Plug in the power cord while pressing the [Z] button.

Note: This method is same as “CD Start Mode” of test modes. Load the 

start disc and close the disc tray, and if the start disc is not recog-
nized, start the CD as usual.

; botton