Read Sony MHC-SV7AV / TA-SV7AV Service Manual online
3
TA-SV7AV
SECTION 1
SERVICING NOTES
This set is a component of the MHC-SV7AV.
The MHC-SV7AV system configuration is as shown below, and
therefore it does not operate normally unless all four components
are connected.
In performing the repair, connect all components with the system
cables.
Note: The precaution to the users is described on the label stuck
on the back panel (Video CD player) and in the troubleshooting
section in the Operation Manual.
The MHC-SV7AV system configuration is as shown below, and
therefore it does not operate normally unless all four components
are connected.
In performing the repair, connect all components with the system
cables.
Note: The precaution to the users is described on the label stuck
on the back panel (Video CD player) and in the troubleshooting
section in the Operation Manual.
System Configuration:
POWER SUPPLY
AC IN
TA
MASTER & GRAPHIC
µ
con
ST
MCE
TC
µ
con
TC
DISPLAY
HTC & VMP
µ
con
MODEL IDENTIFICATION
– Back Panel –
PART No.
Model
PART No.
Singapore model
4-233-558-2
[]
Saudi Arabia model
4-233-558-3
[]
Thailand model
4-233-558-4
[]
FRONT AMP BOARD SERVICE POSITION
In checking the FRONT AMP board, prepare jig
(extension cable J-2501-019-A: 1.25 mm Pitch, 25 core, Length
300 mm)
(Fig A)
(extension cable J-2501-019-A: 1.25 mm Pitch, 25 core, Length
300 mm)
(Fig A)
Turn over the FRONT AMP board with Heat Sink,
SURROUND AMP board and RELAY board connected.
SURROUND AMP board and RELAY board connected.
Remove the back panel
(2CH/VCD) section.
(2CH/VCD) section.
Remove the fan motor
connector lead wire.
connector lead wire.
FRONT AMP board
(CN104)
(CN104)
Connect jig (extension
cable J-2501-019-A
to the FRONT AMP board (CN104)
and PANEL board (CN700).
cable J-2501-019-A
to the FRONT AMP board (CN104)
and PANEL board (CN700).
PANEL board (CN700)
(Fig A)
Click on the first or last page to see other MHC-SV7AV / TA-SV7AV service manuals if exist.