Read Sony MDS-NT1 Service Manual online
22
MDS-NT1
4-5-1. Operating the Continuous Playback Mode
1. Entering the continuous playback mode
(1)
(1)
Set the disc in the unit. (Whichever recordable discs or discs for playback only are available)
(2)
Click the
[JOG UP]
or
[JOG DOWN]
and display “CPLAY2MODE” (C36).
(3)
Click the
[ENTER/YES]
to change the display to “CPLAY2MID”.
(4)
When access completes, the display changes to “C =
AD =
”.
Note:
The numbers “ ” displayed show you error rates and ADER.
2. Changing the parts to be played back
(1)
(1)
Click the
[ENTER/YES]
during continuous playback to change the display as below.
When clicked another time, the parts to be played back can be moved.
(2)
When access completes, the display changes to “C =
AD =
”.
Note:
The numbers “ ” displayed show you error rates and ADER.
3. Ending the continuous playback mode
(1)
(1)
Click the
[MENU/NO]
. The display will change to “CPLAY2MODE” (C36).
(2)
Click the
[EJECT]
and take out the disc.
Note:
The playback start addresses for IN, MID, and OUT are as follows.
IN
40h cluster
MID 300h cluster
OUT 700h cluster
OUT 700h cluster
4-5-2. Operating the Continuous Recording Mode (Use only when performing self-recording/palyback check)
1. Entering the continuous recording mode
(1)
(1)
Set a recordable disc in the unit.
(2)
Click the
[JOG UP]
or
[JOG DOWN]
and display “CREC 2MODE” (C37).
(3)
Click the
[ENTER/YES]
to change the display to “CREC 2MID”.
(4)
When access completes, the display changes to “CREC 2 (
”.
Note:
The numbers “ ” displayed shows you the recording position addresses.
2. Changing the parts to be recorded
(1)
(1)
When the
[ENTER/YES]
is clicked during continuous recording, the display changes as below.
When clicked another time, the parts to be recorded can be changed.
(2)
When access completes, the display changes to “CREC 2 (
”.
Note:
The numbers “ ” displayed shows you the recording position addresses.
3. Ending the continuous recording mode
(1)
(1)
Click the
[MENU/NO]
. The display changes to “CREC 2MODE” (C37).
(2)
Click the
[EJECT]
and take out the disc.
Note 1:
The recording start addresses for IN, MID, and OUT are as follows.
IN
40h cluster
MID 300h cluster
OUT 700h cluster
OUT 700h cluster
Note 2:
The
[MENU/NO]
can be used to stop recording anytime.
Note 3:
Do not perform continuous recording for long periods of time above 5 minutes.
Note 4:
During continuous recording, be careful not to apply vibration.
“CREC 2MID” t “CREC 2OUT” t “CREC 2IN”
“CREC 2MID” t “CREC 2OUT” t “CREC 2IN”
Click on the first or last page to see other MDS-NT1 service manuals if exist.