ICF-CD523 - Sony Audio Service Manual (repair manual). Page 4

4

This section is extracted from
instruction manual.

u

u

A

A)

The unit can be installed without the spacer.

Mark the position of the 4 holes by using
the supplied template. Use a drill to make
the holes (size 6.5 mm dia., 

9

/

32

 inch). (See

Fig.

A- )

When the cabinet door overhangs the shelf
and obstructs the unit, you can adjust the
unit/shelf height.
First set the L mark to the dot which
becomes the lowest position, then you can
adjust the height in 4 steps (H••L) by
turning the spacer counterclockwise. (See
Fig.

A- )

Install the unit with the supplied mounting
screws. (See Fig. 

A- )

• Since the unit is very heavy, be careful when

installing the unit.

• You need two people to install the unit.
• Be careful with the tools you use when installing

the unit.

• Be sure that the cabinet is sturdy enough to support

the weight of the unit.

• To reduce the risk of fire, do not place any heating

or cooking appliance beneath this unit.

• Install the unit so that its AC power cord can be

connected directly to a wall outlet. Do not use a
converter or extension cord.

• Be sure that the AC power cord has no slack when

using the unit, since the cord acts as an FM wire
antenna. If the AC power cord has some slack,
wind it up to the cord hook until the cord has no
slack.

• The unit has a built-in ferrite bar antenna for AM

radio reception. Check the condition of AM
reception before fixing in position.

• Install the unit as far as possible from a source of

noise. (for example, refrigerator, microwave oven,
fluorescent lamp, etc.)

• This unit is not waterproof. The unit should be

installed where it will not be exposed to splashing
water, which could damage the unit.

• To reduce the risk of fire or electric shock, do not

touch the AC power cord with wet hands.

• Never place objects between the top of the unit and

the bottom of the cabinet. This could cause the unit
to fall.

Plug in the clock radio.

The display will flash “AM 12:00” or “0:00”.

Press CLOCK for a few seconds.

You will hear a beep and the hour will start to
flash in the display.

Press TUNE/TRACK/TIME SET + or
– until the correct hour appears in the
display.

Press CLOCK once.

The minute will flash.

Repeat steps 3 and 4 to set the minute.

After setting the minute, press 

 to start

the counting of the seconds, and you will hear two
short beeps.

• To set the current time rapidly, hold down

 or 

.

• The clock system varies depending on the model

you own.
12-hour system: “AM 12:00” = midnight
24-hour system: “0:00” = midnight

• In step 

, when you press 

after the minute

setting to activate the clock, the seconds  start
counting from zero.

Press D.S.T.•SUMMER T..

“

” is displayed and the time indication changes to

summer time.
To deactivate the summer time function, press

 again.