Read Sony ICD-P630F Service Manual online
SERVICE MANUAL
Sony Corporation
Audio&Video Business Group
Published by Sony Techno Create Corporation
ICD-P630F
SPECIFICATIONS
IC RECORDER
9-889-044-03
2008G04-1
©
2008.07
AEP Model
E Model
Ver. 1.2 2008.07
IC recorder section
Recording media
Recording media
recording
A part of the memory capacity is used as a
management area.
A part of the memory capacity is used as a
management area.
Recording time
HQ: 59 hours 45 minutes
SP: 159 hours 20 minutes
LP: 261 hours 45 minutes
SP: 159 hours 20 minutes
LP: 261 hours 45 minutes
Freqency range
HQ: 260 Hz - 6,800 Hz
SP/LP: 220 Hz - 3,400 Hz
SP/LP: 220 Hz - 3,400 Hz
Speaker
Approx. 2.8 cm dia.
Power output
250 mW
Input/Output
Headphone jack (minijack) for 8 - 300 ohms
ear receiver/headphones
ear receiver/headphones
[
Microphone jack (minijack, monaural)
Plug in power
Minimum input level 0.6 mV
3 kilohms or lower impedance microphone
USB connector
Plug in power
Minimum input level 0.6 mV
3 kilohms or lower impedance microphone
USB connector
Power requirements
Two LR03 (size AAA) alkaline batteries: 3 V DC
Dimensions (w/h/d) (not incl.
projecting parts and controls)
projecting parts and controls)
34.6 × 109.2 × 18.4 mm
Mass (incl. batteries)
68 g
Supplied accessories
Operating instructions (1)
LR03 (size AAA) alkaline batteries (2)
Headphone (1)
Carrying pouch (1) (excluding Europe)
USB connecting cable (1)
Application software (CD-ROM) (1)
LR03 (size AAA) alkaline batteries (2)
Headphone (1)
Carrying pouch (1) (excluding Europe)
USB connecting cable (1)
Application software (CD-ROM) (1)
change without notice.
[
[
FM radio section
Frequency range
Frequency range
87.5 - 108 MHz
IF 225 kHz
IF 225 kHz
Antennas
Headphone cord antenna
General
Built-in flash memory 512 MB, Monaural
Design and specifications are subject to
ICD-P630F
2
1. GENERAL
.................................................................. 3
2. DISASSEMBLY
2-1. Case (Front) Assy ........................................................... 4
2-2. Main Board ..................................................................... 5
2-3. USB/FM Board ............................................................... 5
2-2. Main Board ..................................................................... 5
2-3. USB/FM Board ............................................................... 5
3.
TEST MODE
............................................................
6
4. DIAGRAMS
4-1. Block
Diagram
................................................................ 9
4-2. Printed Wiring Board –MAIN Section– ......................... 11
4-3. Schematic Diagram –MAIN Section (1/2)– ................... 12
4-4. Schematic Diagram –MAIN Section (2/2)– ................... 13
4-5. Printed Wiring Board –USB/FM Section– ..................... 14
4-6. Schematic Diagram –USB/FM Section– ........................ 15
4-3. Schematic Diagram –MAIN Section (1/2)– ................... 12
4-4. Schematic Diagram –MAIN Section (2/2)– ................... 13
4-5. Printed Wiring Board –USB/FM Section– ..................... 14
4-6. Schematic Diagram –USB/FM Section– ........................ 15
5.
EXPLODED VIEWS
5-1. Case (Front) Section ....................................................... 18
5-2. Case (Rear) Section ........................................................ 19
5-2. Case (Rear) Section ........................................................ 19
6.
ELECTRICAL PARTS LIST
.............................. 20
TABLE OF CONTENTS
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher
• Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if the
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if the
heated tip is applied for too long, so be careful!
• Strong
viscosity
Unleaded solder is more viscous (sticky, less prone to fl ow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
•
Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
also be added to ordinary solder.
Notes on chip component replacement
•
•
Never reuse a disconnected chip component.
•
Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
aged by heat.
Flexible Circuit Board Repairing
•
•
Keep the temperature of soldering iron around 270 °C during
repairing.
repairing.
•
Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
circuit board (within 3 times).
•
Be careful not to apply force on the conductor when soldering
or unsoldering.
or unsoldering.
ICD-P630F
3
SECTION 1
GENERAL
This section is extracted
from instruction manual.
from instruction manual.
6
GB
Index to Parts and Controls
Main unit
Built-in microphone
(microphone) jack
Display window
DISPLAY/MENU
FM•
J (headphone)/ (speaker) selector
Y(stop)
[9REC (record)
–
(review/fast backward)/
+ (cue/fast forward)
Speaker
J (headphone) jack
Operation indicator
DIVIDE
VOL (volume) control*
HOLD
/YPLAY/ENTER**
* There is a tactile dot beside the control to show
the direction to turn up the volume.
** The button has a tactile dot.
7
GB
Preventing Accidental Operation
— HOLD function
— HOLD function
Slide the HOLD switch to ON. “HOLD” will flash
three times, indicating that all the functions of
the buttons are locked.
When the HOLD function is activated during
stop, all the display will be turned off after
“HOLD” flashes.
three times, indicating that all the functions of
the buttons are locked.
When the HOLD function is activated during
stop, all the display will be turned off after
“HOLD” flashes.
HOLD
To cancel the HOLD function
Slide the HOLD switch to OFF.
Note
When the HOLD function is activated during
recording, cancel the HOLD function first to
stop recording.
recording, cancel the HOLD function first to
stop recording.
Tip
Even if the HOLD function is activated, you can
stop the alarm playback. To stop the alarm or
playback, press
stop the alarm playback. To stop the alarm or
playback, press
Y(stop).
1
[
Rear
USB connector
Battery compartment
Hook for handstrap
(not supplied)
(not supplied)
8
GB
Display window
Folder indication
Microphone sensitivity
Alarm indicator
Selected message
number
REC DATE (recorded date)
indication
REMAIN indicator
FM radio sensitivity
Remaining memory
indicator
Remaining battery
indicator
Recording mode
indication
REC (recording)
indicator
FM indicator
indicator
Recording mode
indication
REC (recording)
indicator
FM indicator
Repeat play indicator
EASY-S (Easy Search)
indicator
Number of messages
in a folder/Menu
indication/Counter/
Remaining time
indication /Recording
date indication/
Current time indication/
Messages
indicator
Number of messages
in a folder/Menu
indication/Counter/
Remaining time
indication /Recording
date indication/
Current time indication/
Messages
ICD-P630F
4
SECTION 2
DISASSEMBLY
• This set can be disassembled in the order shown below.
Note:
Follow the disassembly procedure in the numerical order given.
2-1. CASE (FRONT) ASSY
2-1. CASE
(FRONT)
ASSY
(Page
4)
2-2. MAIN
BOARD
(Page
5)
SET
2-3. USB/FM
BOARD
(Page
5)
R
screw
RB two screws
RT two brackets (speaker)
RE speaker
RG case (front) assy
claw
claw
claw
claw
two claws
battery case lid
claw
claw