ICD-BP220 - Sony Audio Service Manual (repair manual). Page 6

Read Sony ICD-BP220 Service Manual online

6
ICD-BP220
SECTION 3
DIAGRAMS
Note on Schematic Diagrams:
• All capacitors are in 
µ
F unless otherwise noted.  pF: 
µµ
F
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in 
 and 
1
/
4
 
W or less unless otherwise
specified.
f
: internal component.
C
: panel designation.
A
: B+ Line.
• Power voltage is dc 3V and fed with regulated dc power
supply from battery terminal.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : REC
(
) : PB
• Voltages are taken with a VOM (Input impedance 10 M
).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
E
: PB
a
: REC
*
Replacement of IC109 used in this set requires a special
tool.
The voltage and waveform of CSP (chip size package)
cannot be measured, because its lead layout is different
from that of conventional IC.
Note on Printed Wiring Boards:
• Y
: parts extracted from the conductor side.
• b
: Pattern from the side which enables seeing.
Caution:
Pattern face side:
Parts on the pattern face side seen from
(SIDE B)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(SIDE A)
the parts face are indicated.
*
Replacement of IC109 used in this set requires a special
tool.
Lead layouts
• WAVEFORMS
1.3 Vp-p
4.096 MHz
1
 IC712 
od
 XTAL 
VOLT/DIV : 0.5 V AC
TIME/DIV : 50 nsec
0.8 Vp-p
3.2 Vp-p
32.768 kHz
2
 IC716 
8
 oscout
3
 IC508 
5
 EXT
VOLT/DIV : 0.2 V AC
TIME/DIV : 10 
µ
sec
VOLT/DIV : 1.0 V DC
TIME/DIV : 2 
µ
sec
3.3 
µ
s
surface
Lead layout of
conventional IC
CSP (chip size package)
Page of 29
Display

Click on the first or last page to see other ICD-BP220 service manuals if exist.