HTR-6100, HTR-6600, HT-SL600, HT-SL800, STR-KSL600 - Sony Audio Service Manual (repair manual)

htr-6100, htr-6600, ht-sl600, ht-sl800, str-ksl600 service manual
Model
HTR-6100 HTR-6600 HT-SL600 HT-SL800 STR-KSL600
Pages
45
Size
4.05 MB
Type
PDF
Document
Service Manual
Brand
Device
Audio
File
htr-6100-htr-6600-ht-sl600-ht-sl800-str-ksl600.pdf
Date

Read Sony HTR-6100 / HTR-6600 / HT-SL600 / HT-SL800 / STR-KSL600 Service Manual online

SERVICE MANUAL
FM STEREO/FM-AM RECEIVER
AEP Model
UK Model
SPECIFICATIONS
STR-KSL600
Ver. 1.1  2006.03
9-879-050-02
2006C05-1
© 2006.03
Sony Corporation
Home Audio Division
Published by Sony Techno Create Corporation
STR-KSL600 is the receiver section in HT-SL600/SL800.
This receiver incorporates Dolby* Digital and Pro
Logic Surround and the DTS** Digital Surround
System.
* Manufactured under license from Dolby
Laboratories.
“Dolby”, “Pro Logic” and the double-D symbol are
trademarks of Dolby Laboratories.
** “DTS” and “DTS Digital Surround” are registered
trademarks of Digital Theater Systems, Inc.
Outputs (Analog)
SUB WOOFER
Voltage: 2 V
Impedance: 1 kiloohms
Amplifier section
Power Output
Models of area code CEL, CEK
(6 ohms 1 kHz, THD 0.7%)
1)
FRONT
2)
: 40 W/ch
CENTER
2)
: 40 W
SURR
2)
: 40 W/ch
(6 ohms 1 kHz, THD 10%)
1)
FRONT
2)
: 60 W/ch
CENTER
2)
: 60 W
SURR
2)
: 60 W/ch
1) Measured under the following conditions:
Area code
Power requirements
CEL, CEK
230 V AC, 50 Hz
Inputs (Analog)
Inputs (Digital)
TV/SAT, DVD, VIDEO 
Sensitivity: 500 mV
Impedance: 50 kiloohms
DVD (Coaxial)
Sensitivity: 
Impedance: 75 ohms
DVD, TV/SAT (Optical)
Sensitivity: 
Impedance: 
2) Depending on the sound field settings and the 
source, there may be no sound output.
Reproduction frequency range:
28 
− 20,000 Hz
Tone
FM tuner section
Tuning range
87.5 
− 108.0 MHz 
Antenna
FM wire antenna
Antenna terminals
75 ohms, unbalanced
Intermediate Frequency
10.7 MHz
AM tuner section
Tuning range
Models of area code CEL, CEK
With 9-kHz tuning scale:  531 
− 1,602 kHz
Antenna
Loop antenna
Intermediate Frequency
450 kHz
Video section
Inputs/Outputs
Video:
1 Vp-p, 75 ohms
Gain levels
±6 dB, 1 dB step
General
Power requirements
Area code
Power requirements
CEL, CEK
230 V AC, 50/60 Hz
Power consumption
Power consumption (during standby mode)
0.3 W
Dimensions (w/h/d) (Approx.)
430 
× 352 × 66 mm
including projecting parts 
and controls
Mass (Approx.)
5.5 kg
Area code
Power consumption
CEL, CEK
170 W 
Design and specifications are subject to change 
without notice.
2
STR-KSL600
TABLE  OF  CONTENTS
1.
SERVICING  NOTES
...............................................
3
2.
GENERAL
...................................................................
4
3.
DISASSEMBLY
3-1.
Disassembly Flow ...........................................................
5
3-2.
Case (SL500) ...................................................................
5
3-3.
Front Panel Section .........................................................
6
3-4.
MAIN Board ....................................................................
6
4.
TEST  MODE
..............................................................
7
5.
DIAGRAMS
5-1.
Block Diagram  
− AUDIO DSP/VIDEO Section − ......... 8
5-2.
Block Diagram  
− TUNER/AUDIO AMP Section −....... 9
5-3.
Block Diagram
− DISPLAY/POWER SUPPLY Section − ....................... 10
5-4.
Printed Wiring Board
− DIGITAL Board (Component Side) − ......................... 12
5-5.
Printed Wiring Board
− DIGITAL Board (Conductor Side) − ........................... 13
5-6.
Schematic Diagram  
− DIGITAL Board (1/4) −.............. 14
5-7.
Schematic Diagram  
− DIGITAL Board (2/4) −.............. 15
5-8.
Schematic Diagram  
− DIGITAL Board (3/4) −.............. 16
5-9.
Schematic Diagram  
− DIGITAL Board (4/4) −.............. 17
5-10. Printed Wiring Board  
− I/O Board − .............................. 18
5-11. Schematic Diagram  
− I/O Board − ................................. 19
5-12. Printed Wiring Board  
− MAIN Board − ......................... 20
5-13. Printed Wiring Board  
− STBY Board − ......................... 21
5-14. Schematic Diagram  
− MAIN Section (1/2) − ................ 22
5-15. Schematic Diagram  
− MAIN Section (2/2) − ................ 23
5-16. Printed Wiring Boards  
− PANEL Section − ................... 24
5-17. Schematic Diagram  
− PANEL Section − ....................... 25
6.
EXPLODED  VIEWS
6-1.
Front Panel Section ......................................................... 35
6-2.
Chassis Section ................................................................ 36
7.
ELECTRICAL  PARTS  LIST
................................ 37
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
SAFETY-RELATED  COMPONENT  WARNING!!
COMPONENTS  IDENTIFIED  BY  MARK 
 0
  OR  DOTTED  LINE
WITH  MARK  
0
  ON  THE  SCHEMATIC  DIAGRAMS  AND  IN
THE  PARTS  LIST  ARE  CRITICAL  TO  SAFE  OPERATION.
REPLACE  THESE  COMPONENTS  WITH  SONY  PARTS  WHOSE
PART  NUMBERS  APPEAR  AS  SHOWN  IN  THIS  MANUAL  OR
IN  SUPPLEMENTS  PUBLISHED  BY  SONY.
3
STR-KSL600
SECTION  1
SERVICING  NOTES
UNLEADED  SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD  FREE  MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 
°C.
Caution: The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscou-s (sticky, less prone to flow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
PART No.
– Back Panel –
MODEL  IDENTIFICATION
MODEL
PART No.
AEP model
4-254-456-2[]
UK model
4-254-456-3[]
4
STR-KSL600
SECTION  2
GENERAL
This section is extracted from
instruction manual.
LOCATION  OF  CONTROLS
– Front Panel –
– Remote Commander –
Remote 
Button
Operations
Function
ANGLE 6 DVD  player
Selects viewing angle or 
changes the angles.
ANT 8
VCR
Selects output signal 
from the antenna 
terminal: TV signal or 
VCR program.
AUDIO 6 TV/VCR/
DVD player
Changes the sound to 
Multiplex or Bilingual 
or Multi Channel TV 
Sound.
AUX 4
Receiver
To listen to an audio 
equipment.
AV MENU 
qa
VCR/
satellite tuner/
DVD player
Displays menu.
AV ?/1 
e;
TV/VCR/
CD player/
DVD player
Turns the audio and 
video components on or 
off.
CLEAR 8 DVD player
Press if you make a 
mistake when you press 
the numeric button or 
press to return to 
continuous play etc.
DISC wa
CD player
Selects a disc directly 
(multi-disc changer 
only).
DISPLAY 
qa
TV/VCR/
DVD player
Selects information 
displayed on the TV 
screen.
D.TUNING 
6
Receiver
Enters direct tuning 
mode.
DUAL 
MONO 6
Receiver
Selects the language 
you want during digital 
broadcast.
DVD 2
Receiver
To watch DVD.
Remote 
Button
Operations
Function
ENTER qa Receiver/
VCR/
satellite tuner/
DVD player
Enters the selection.
ENTER/12 
wd
TV/VCR/
satellite tuner
Enters the selection.
FM MODE 
6
Receiver
Selects FM monaural or 
stereo reception.
JUMP 6
TV
Toggles between the 
previous and the current 
channels.
MAIN 
MENU qj
Receiver
Selects the menu of the 
receiver.
MASTER 
VOL +/– 
qk
Receiver
Adjusts the master 
volume of the receiver.
MEMORY 
7
Receiver
Stores the radio stations.
MUTING 
ql
Receiver
Mutes the sound from 
the receiver.
PRESET/
Receiver
Selects preset stations.
CH/D.SKIP 
+/– wf
TV/VCR/
satellite tuner
Selects preset channel.
CD player/
DVD player
Skips discs (multi-disc 
changer only).
RETURN/
EXIT/O 
DVD player
Returns to the previous 
menu or exits the menu.
qa
Satellite tuner Exits the menu.
SAT wk
Receiver
To watch satellite tuner.
SEARCH 
MODE wa
DVD player
Selects searching mode. 
Press to select the unit 
for search (track, index, 
etc.)
Remote 
Button
Operations
Function
A.F.D. wh Receiver
Selects A.F.D. AUTO.
ALT ws
Remote
When ALT button lights 
up, it changes the remote 
key function to activate 
those buttons with orange 
printing.
H
X
m
M
.
>
-
VIDEO
DVD
SYSTEM STANDBY SLEEP
TV 
?/1
AV 
?/1
SAT
TV
AUX
TUNER
;
PL/PL
A.F.D.
TOP MENU/
GUIDE
AV MENU
MUTING
MASTER
VOL
DISPLAY
TV VOL
TV CH
WIDE
TEST
TONE
TV/
VIDEO
MAIN
MENU
RETURN/EXIT
TUNING
DISC
ALT
ANT
CLEAR SEARCH MODE
DUAL
MONO
FM MODE
1
2
3
4
5
6
7
8
9
0/10
>10/11
ENTER/12
D.TUNING
MEMORY
SHIFT
SOUND
FIELD
TIME
SWAP
JUMP
PRESET/
CH/D.SKIP
AUDIO
ANGLE
SUBTITLE
x
?/1
O
ENTER
f
F
G
g
1
e;
ea
2
wl
wh
wg
wf
wd
ws
wa
9
w;
ql
qk
qa
q;
3
6
7
qs
qd
8
qg
qh
qj
qf
5
4
wj
wk
Display 2
DVD (indicator) 5
INPUT SELECTOR qd
IR (receptor) 3
MASTER VOLUME qf
MUTING qs
PRESET TUNING + 9
PRESET TUNING 
− 8
SOUND FIELD qa
TUNER (indicator) 7
TV/SAT (indicator) 6
VIDEO (indicator) 4
?/1 (power) 1
; PLII q;
ALPHABETICAL ORDER
NUMBERS AND SYMBOLS
1
2
3
4 5 6
8 9 q; qa qs qd
qf
7
Page of 45
Display

Download Sony HTR-6100 / HTR-6600 / HT-SL600 / HT-SL800 / STR-KSL600 Service Manual (Repair Manual)

Here you can read online and download Sony HTR-6100 / HTR-6600 / HT-SL600 / HT-SL800 / STR-KSL600 Service Manual in PDF. HTR-6100 / HTR-6600 / HT-SL600 / HT-SL800 / STR-KSL600 service manual will guide through the process and help you recover, restore, fix, disassemble and repair Sony HTR-6100 / HTR-6600 / HT-SL600 / HT-SL800 / STR-KSL600 Audio. Information contained in service manuals typically includes schematics / circuit diagrams, wiring diagrams, block diagrams, printed wiring boards, exploded views, parts list, disassembly / assembly, pcb.