Read Sony HTC-NX1 / MHC-NX1 / MHC-NX3AV Service Manual online
3
POWER SUPPLY DURING SERVICING
• As this set has not own power supply, it does not operate inde-
pendently. Therefore, during servicing, connect it to the Pre-
Main amplifier and Tuner Unit (STR-NX1/NX3) of MHC-NX1/
NX3AV.
Main amplifier and Tuner Unit (STR-NX1/NX3) of MHC-NX1/
NX3AV.
If STR-NX1/NX3 are not available, use the Power Feed Jig (PFJ-
1) and Relay Connector Jig.
In this case, after turn on the POWER switch on the Power Feed
Jig, supply power with the following methods.
1) and Relay Connector Jig.
In this case, after turn on the POWER switch on the Power Feed
Jig, supply power with the following methods.
Procedure:
1. Press three buttons of s (DECK B), A (DISC 1),
1. Press three buttons of s (DECK B), A (DISC 1),
and s (CD) simultaneously.
2. The G (CD) and S (CD) LEDs blink, and then pressing G
(CD), G / g (DECK A), or G / g (DECK B) button can
make each play possible.
make each play possible.
3. Also, the other functions are enabled by pressing two buttons
simultaneously.
A combination of respective functions and buttons is as fol-
lows.
A combination of respective functions and buttons is as fol-
lows.
function
button
CD AMS –
s (DECK A), S (CD)
AMS +
s (DECK A), s (CD)
FR
s (DECK B), S (CD)
FF
s (DECK B), s (CD)
Deck-A REW/AMS –
s (CD), g (DECK A)
FF/AMS +
s (CD), G (DECK A)
Deck-B REW/AMS –
s (CD), g (DECK B)
FF/AMS +
s (CD), G (DECK B)
Set
SYSTEM CONTROL terminal
SYSTEM CONTROL terminal
Connector cable (19P)
Pre-Main AMP
and Tuner Unit
and Tuner Unit
AC IN
Power feed jig
(PFJ-1)
(PFJ-1)
Connector cable (17P) of
attachment to power feed jig
attachment to power feed jig
Relay connector jig
(J-2501-174-A)
(J-2501-174-A)
CD/TC signal
change switch
change switch
CN101 (15P)
SYSTEM CONTROL
terminal
SYSTEM CONTROL
terminal
system cable
Exclusive cable (15P)
P707, P909
Set
CDP/TC
ST
Connection:
Click on the first or last page to see other HTC-NX1 / MHC-NX1 / MHC-NX3AV service manuals if exist.