Read Sony HT-XT100 Service Manual online
HT-XT100
4
SECTION 1
SERVICING NOTES
The SERVICING NOTES contains important information for servicing. Be sure to read this section before repairing the unit.
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher
• Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful!
• Strong
viscosity
Unleaded solder is more viscous (sticky, less prone to fl ow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
•
Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
also be added to ordinary solder.
DESTINATION ABBREVIATIONS
The following abbreviations for model destinations are used in this
service manual.
The following abbreviations for model destinations are used in this
service manual.
• Abbreviations
AUS :
AUS :
Australian
model
CND : Canadian model
RU
RU
: Russian model
MODEL IDENTIFICATION
Distinguish by model number label stuck on the rear side of a main
unit.
Distinguish by model number label stuck on the rear side of a main
unit.
Note: The printed contents of following fi gure model number label may
be different from the model number label of a main unit.
– Rear view –
US and Canadian models (UC2)
MODEL NUMBER LABEL
UK model (CEK)
AEP model (CEL)
Australian model (AU1)
4-562-642-0
[]
4-562-643-0
[]
4-562-644-0
[]
4-562-779-0
[]
Russian model (RU3)
4-562-790-0
[]
Ver. 1.1
Click on the first or last page to see other HT-XT100 service manuals if exist.