HT-ST5 - Sony Audio Service Manual (repair manual). Page 2

Read Sony HT-ST5 Service Manual online

HT-ST5
2
NOTES  ON  CHIP  COMPONENT  REPLACEMENT
• 
Never reuse a disconnected chip component.
• 
Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
SAFETY  CHECK-OUT
After correcting the original service problem, perform the follow-
ing safety check before releasing the set to the customer:
Check the antenna terminals, metal trim, “metallized” knobs, 
screws, and all other exposed metal parts for AC leakage.
Check leakage as described below.
LEAKAGE  TEST
The AC leakage from any exposed metal part to earth ground and 
from all exposed metal parts to any exposed metal part having a 
return to chassis, must not exceed 0.5 mA (500 microamperes.). 
Leakage current can be measured by any one of three methods.
1.  A commercial leakage tester, such as the Simpson 229 or RCA 
WT-540A. Follow the manufacturers’ instructions to use these 
instruments.
2.  A battery-operated AC milliammeter. The Data Precision 245 
digital multimeter is suitable for this job.
3.  Measuring the voltage drop across a resistor by means of a 
VOM or battery-operated AC voltmeter. The “limit” indication 
is 0.75 V, so analog meters must have an accurate low-voltage 
scale. The Simpson 250 and Sanwa SH-63Trd are examples 
of a passive VOM that is suitable. Nearly all battery operated 
digital multimeters that have a 2 V AC range are suitable. (See 
Fig. A)
1.5 k
Ω
0.15 
μF
AC
voltmeter
(0.75 V)
To Exposed Metal
Parts on Set
Earth Ground
Fig. A.  Using an AC voltmeter to check AC leakage.
Accessories
Remote control (1)
R03 (size AAA) batteries (2)
Optical digital cable for a TV (1)
Startup Guide (1)
Operating Instructions (1)
Video formats supported by the system
Input/Output (HDMI Repeater block)
*1
YCbCr 4:2:0/Supported 8-bit only
*2
Supported 8-bit only
Design and specifications are subject to change without notice.
Format
2D
3D
Frame 
packing
Side-by-
Side (Half)
Over-Under 
(Top-and-
Bottom)
4096 × 2160p @ 59.94/60 Hz
*1
4096 × 2160p @ 50 Hz
*1
4096 × 2160p @ 23.98/24 Hz
*2
3840 × 2160p @ 59.94/60 Hz
*1
3840 × 2160p @ 50 Hz
*1
3840 × 2160p @ 29.97/30 Hz
*2
3840 × 2160p @ 25 Hz
*2
3840 × 2160p @ 23.98/24 Hz
*2
1920 × 1080p @ 59.94/60 Hz
1920 × 1080p @ 50 Hz
1920 × 1080p @ 29.97/30 Hz
1920 × 1080p @ 25 Hz
1920 × 1080p @ 23.98/24 Hz
1920 × 1080i @ 59.94/60 Hz
1920 × 1080i @ 50 Hz
1280 × 720p @ 59.94/60 Hz
1280 × 720p @ 50 Hz
1280 × 720p @ 29.97/30 Hz
1280 × 720p @ 23.98/24 Hz
720 × 480p @ 59.94/60 Hz
720 × 576p @ 50 Hz
640 × 480p @ 59.94/60 Hz
This system incorporates Dolby* Digital and the DTS** Digital Surround 
System.
*
Manufactured under license from Dolby Laboratories.
Dolby, and the double-D symbol are trademarks of Dolby 
Laboratories.
** For DTS patents, see http://patents.dts.com. Manufactured under 
license from DTS Licensing Limited. DTS, DTS-HD, the Symbol, & DTS 
and the Symbol together are registered trademarks, and DTS-HD 
Master Audio is a trademark of DTS, Inc. © DTS, Inc. All Rights 
Reserved.
The BLUETOOTH® word mark and logos are registered trademarks owned 
by Bluetooth SIG, Inc. and any use of such marks by Sony Corporation is 
under license.
This system incorporates High-Definition Multimedia Interface (HDMI™) 
technology. 
The terms HDMI and HDMI High-Definition Multimedia Interface, and the 
HDMI Logo are trademarks or registered trademarks of HDMI Licensing 
LLC in the United States and other countries.
The N Mark is a trademark or registered trademark of NFC Forum, Inc. in 
the United States and in other countries.
Android and Google Play are trademarks of Google Inc.
© 2013 CSR plc and its group companies.
The aptX® mark and the aptX logo are trade marks of CSR plc or one of its 
group companies and may be registered in one or more jurisdictions.
Apple, the Apple logo, iPhone, iPod, and iPod touch are trademarks of 
Apple Inc., registered in the U.S. and other countries. App Store is a 
service mark of Apple Inc.
“Made for iPod,” and “Made for iPhone” mean that an electronic 
accessory has been designed to connect specifically to iPod or iPhone, 
respectively, and has been certified by the developer to meet Apple 
performance standards. Apple is not responsible for the operation of this 
device or its compliance with safety and regulatory standards. Please 
note that the use of this accessory with iPod or iPhone may affect 
wireless performance.
Compatible iPod/iPhone models
The compatible iPod/iPhone models are as follows. Update your iPod/
iPhone with the latest software before using with the system.
BLUETOOTH technology works with:
iPhone
iPhone 5s/iPhone 5c/iPhone 5/iPhone 4s/iPhone 4/iPhone 3GS
iPod touch
iPod touch (5th generation)/iPod touch (4th generation)
“BRAVIA” logo is a trademark of Sony Corporation.
“ClearAudio+” is a trademark of Sony Corporation.
“x.v.Color” and “x.v.Color” logo are trademarks of Sony Corporation.
“PlayStation
®
” is a registered trademark of Sony Computer Entertainment  
Inc.
Other trademarks and trade names are those of their respective owners.
Copyrights
SAFETY-RELATED  COMPONENT  WARNING!
COMPONENTS  IDENTIFIED  BY  MARK  
0  OR  DOTTED  LINE  
WITH  MARK  
0  ON  THE  SCHEMATIC  DIAGRAMS  AND  IN  
THE  PARTS  LIST  ARE  CRITICAL  TO  SAFE  OPERATION.
REPLACE  THESE  COMPONENTS  WITH  SONY  PARTS 
 
WHOSE  PART  NUMBERS  APPEAR  AS  SHOWN  IN  THIS  
MANUAL  OR  IN  SUPPLEMENTS  PUBLISHED  BY  SONY.
ATTENTION  AU  COMPOSANT  AYANT  RAPPORT  
À  LA  SÉCURITÉ!
LES  COMPOSANTS  IDENTIFIÉS  PAR  UNE  MARQUE  
0  SUR  
LES  DIAGRAMMES  SCHÉMATIQUES  ET  LA  LISTE  DES  
PIÈCES  SONT  CRITIQUES  POUR  LA  SÉCURITÉ  DE  FONC-
TIONNEMENT.  NE  REMPLACER  CES  COMPOSANTS  QUE  
PAR  DES  PIÈCES  SONY  DONT  LES  NUMÉROS  SONT  DON-
NÉS  DANS  CE  MANUEL  OU  DANS  LES  SUPPLÉMENTS  
PUBLIÉS  PAR  SONY.
Page of 72
Display

Click on the first or last page to see other HT-ST5 service manuals if exist.