Read Sony HT-RT5 Service Manual online
HT-RT5
20
2-12. MB-1414 BOARD
OK
NG
3 five screws
(BV3
u 7)
3 screw
(BV3
u 7)
6 two radiation sheets
2 copper foil shield
1 Remove three
places of bond.
2 copper foil shield
2 copper foil
shield
4 heat sink (MB)
9 chassis (MB) block
7 claw
7 claw
0 MB-1414 board
radiation sheet
hole
Radiation sheet is visible.
Radiation sheet is not visible.
hole
(US, CND (Former type))
(See Note 1)
(See Note 1)
(US, CND (New type) and except AR) (See Note 1)
,nVtaOOatLon poVLtLon oI tKe copper IoLO VKLeOd
,nVtaOOatLon poVLtLon oI tKe copper IoLO VKLeOd
guideline
guideline
guideline
bond
copper foil shield
copper foil shield
bond
bond
rear side
rear side
5 four screws
(B3
u 5)
8
Remove the MB-1414 board
in the direction of the arrow.
center of four HDMI jacks
center of three HDMI jacks
1 Remove three
places of bond.
1 Remove two
places of bond.
Note 3: When installing the MB-1414 board to
the chassis (MB) block, check that the
radiation sheet is visible.
Note 2: When installing the copper foil shield,
fix it by using the bond (SC608Z2).
This bond is the same as for fixing the
switching regulator. Refer to page 8
for the parts code.
Note 2: When installing the copper foil shield, fix it by using the
bond (SC608Z2). This bond is the same as for fixing the
switching regulator. Refer to page 8 for the parts code.
Ver. 1.2
Note 1: For US and CND models, large copper foil shield have been
deleted, and two copper foil shields has been added from the
midway of production.
midway of production.
Click on the first or last page to see other HT-RT5 service manuals if exist.