Read Sony HT-DDW995 / STR-K995 Service Manual online
14
STR-K995
SECTION 4
DIAGRAMS
For Schematic Diagrams.
Note:
• All capacitors are in
Note:
• All capacitors are in
µ
F unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics and
tantalums.
tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
• %
: indicates tolerance.
•
f
: internal component.
•
2
: nonflammable resistor.
•
5
: fusible resistor.
•
C
: panel designation.
•
A
: B+ Line.
•
B
: B– Line.
• Voltages and waveforms are dc with respect to ground un-
der no-signal (detuned) conditions.
No mark : FM
No mark : FM
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal production
tolerances.
tolerances.
• Waveforms are taken with a oscilloscope.
• Circled numbers refer to waveforms.
• Circled numbers refer to waveforms.
• Signal path.
F
: FM
J
: ANALOG
c
: DIGITAL
I
: VIDEO
For Printed Wiring Boards.
Note:
•
Note:
•
X
: parts extracted from the component side.
•
a
: Through hole.
•
f
: internal component.
•
: Pattern from the side which enables seeing.
• Indication of transistor.
Caution:
Pattern face side:
Pattern face side:
Parts on the pattern face side seen from
(Side B)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Side A)
the parts face are indicated.
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
(In addition to this, the necessary note is printed in each block.)
• Circuit Boards Location
C
B
These are omitted.
E
Q
B
These are omitted.
C
E
Note: The components identified by mark
0
or dotted
line with mark
0
are critical for safety.
Replace only with part number specified.
DIGITAL board
MAIN board
POWER KEY board
DCAC board
HEADPHONE board
STANDBY board
DCDC board
HDMI RE board
VIDEO board
DISPLAY board
VIDEO 3 board
Click on the first or last page to see other HT-DDW995 / STR-K995 service manuals if exist.