Read Sony HT-DDW790 / HT-DDW795 / STR-K790 Service Manual online
13
13
STR-K790
STR-K790
• Circuit Boards Location
SECTION 4
DIAGRAMS
For Schematic Diagrams.
Note:
• All capacitors are in
Note:
• All capacitors are in
µ
F unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics and
tantalums.
tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
• %
: indicates tolerance.
•
f
: internal component.
•
2
: nonflammable resistor.
•
5
: fusible resistor.
•
C
: panel designation.
•
A
: B+ Line.
•
B
: B– Line.
• Voltages and waveforms are dc with respect to ground un-
der no-signal (detuned) conditions.
No mark : FM
No mark : FM
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal production
tolerances.
tolerances.
• Waveforms are taken with a oscilloscope.
• Circled numbers refer to waveforms.
• Circled numbers refer to waveforms.
• Signal path.
F
: FM
J
: ANALOG
c
: DIGITAL
I
: VIDEO
For Printed Wiring Boards.
Note:
•
Note:
•
X
: parts extracted from the component side.
•
a
: Through hole.
•
f
: internal component.
•
: Pattern from the side which enables seeing.
• Indication of transistor.
Caution:
Pattern face side:
Pattern face side:
Parts on the pattern face side seen from
(Side B)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Side A)
the parts face are indicated.
C
B
These are omitted.
E
Q
B
These are omitted.
C
E
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
(In addition to this, the necessary note is printed in each block.)
• Waveforms
– DIGITAL Board –
1
IC1905
9
(MCLK1)
1 V/DIV, 40 ns/DIV
72 ns
3.5 Vp-p
2
IC1101
id
(X1)
1 V/DIV, 20 ns/DIV
41.6
n
s
4.2 Vp-p
3
IC1301
ws
(XIN)
1 V/DIV, 40 ns/DIV
81.4 ns
4.2 Vp-p
DIGITAL board
MAIN board
DISPLAY board
HEADPHONE board
POWER board
DCAC board
STANDBY board
HDMI BRIDGE board (AEP,UK)
HDMI SW board (AEP,UK)
Note:
The components identi-
fied by mark
fied by mark
0
or dot-
ted line with mark
0
are
critical for safety.
Replace only with part
number specified.
Replace only with part
number specified.
Note:
Les composants identifiés
par une marque
par une marque
0
sont cri-
tiques pour la sécurité.
Ne les remplacer que par une
piéce por tant le numéro
spécifié.
Ne les remplacer que par une
piéce por tant le numéro
spécifié.
Click on the first or last page to see other HT-DDW790 / HT-DDW795 / STR-K790 service manuals if exist.