Read Sony HT-DDW5400 / STR-KM5400 Service Manual online
STR-KM5400
3
SECTION 1
SERVICING NOTES
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher
• Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscou-s (sticky, less prone to fl ow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
also be added to ordinary solder.
NOTICE OF CONNECTORS CHECK
When changing DIGITAL board to Suffi x-21, connectors for
CONNECTION board (CNP511, CNS510), DIGITAL board
(CNP505, CNS501, CNS502), MAIN board (CNP410, CNP411,
CNP500) and VIDEO STANDBY SUPLLY board (CNS203,
CNS271) is synchronized. When any of the connector replacement
is necessary, order the connector which mentioned in part list.
When changing DIGITAL board to Suffi x-21, connectors for
CONNECTION board (CNP511, CNS510), DIGITAL board
(CNP505, CNS501, CNS502), MAIN board (CNP410, CNP411,
CNP500) and VIDEO STANDBY SUPLLY board (CNS203,
CNS271) is synchronized. When any of the connector replacement
is necessary, order the connector which mentioned in part list.
Notes on chip component replacement
•
•
Never reuse a disconnected chip component.
•
Notice that the minus side of a tantalum capacitor may be
damaged by heat.
damaged by heat.
Model
Part No.
South African model
4-126-472-7[]
MODEL IDENTIFICATION
Part NO.
– Rear View –
Note: Refer to supplement-1 for the printed wiring board, schematic
diagram of Digital board (Suffi x-21) and electrical part list for
CONNECTION board, DIGITAL board, MAIN board and
VIDEO STANDBY SUPPLY board.
Ver. 1.2
Click on the first or last page to see other HT-DDW5400 / STR-KM5400 service manuals if exist.