HS-AC1 - Sony Audio Service Manual (repair manual). Page 2

COMPONENTS  IDENTIFIED  BY  MARK  0  OR  DOTTED  LINE  
WITH  MARK  0  ON  THE  SCHEMATIC  DIAGRAMS  AND  IN  
THE  PARTS  LIST  ARE  CRITICAL  TO  SAFE  OPERATION.
REPLACE  THESE  COMPONENTS  WITH  SONY  PARTS 

UNLEADED  SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution:  Some printed circuit boards may not come printed with 

the lead free mark due to their particular size)

Unleaded solder has the following characteristics.
•  Unleaded solder melts at a temperature about 40 °C higher 

than ordinary solder.

 

Ordinary soldering irons can be used but the iron tip has to be 
applied to the solder joint for a slightly longer time.

 

Soldering irons using a temperature regulator should be set to 
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if 

the heated tip is applied for too long, so be careful!

• Strong 

viscosity

 

Unleaded solder is more viscous (sticky, less prone to fl ow) 
than ordinary solder so use caution not to let solder bridges 
occur such as on IC pins, etc.

• 

Usable with ordinary solder

 

It is best to use only unleaded solder but unleaded solder may 
also be added to ordinary solder.

NOTES  ON  CHIP  COMPONENT  REPLACEMENT
• 

Never reuse a disconnected chip component.

• 

Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.

 ...................................................................  

3

2-1. D.C 

Fan 

...........................................................................   4

2-2. Power 

Transformer 

.........................................................   5

2-3.  SENSOR Board, AC Board ............................................   5

3-1. Printed 

Wiring 

Boards 

....................................................   7

3-2. Schematic 

Diagram 

.........................................................   8

4-1. Chassis 

Section 

...............................................................   9

4-2.  AC Board Section ...........................................................   10

ELECTRICAL PARTS LIST ..............................   11

SAFETY  CHECK-OUT
After correcting the original service problem, perform the follow-
ing safety check before releasing the set to the customer:
Check the antenna terminals, metal trim, “metallized” knobs, 
screws, and all other exposed metal parts for AC leakage.
Check leakage as described below.

LEAKAGE  TEST
The AC leakage from any exposed metal part to earth ground and 
from all exposed metal parts to any exposed metal part having a 
return to chassis, must not exceed 0.5 mA (500 microamperes.). 
Leakage current can be measured by any one of three methods.
1.  A commercial leakage tester, such as the Simpson 229 or RCA 

WT-540A. Follow the manufacturers’ instructions to use these 
instruments.

2.  A battery-operated AC milliammeter. The Data Precision 245 

digital multimeter is suitable for this job.

3.  Measuring the voltage drop across a resistor by means of a 

VOM or battery-operated AC voltmeter. The “limit” indication 
is 0.75 V, so analog meters must have an accurate low-voltage 
scale. The Simpson 250 and Sanwa SH-63Trd are examples 
of a passive VOM that is suitable. Nearly all battery operated 
digital multimeters that have a 2 V AC range are suitable. (See 
Fig. A)