Read Sony HCD-ZX10D / LBT-ZX10D Service Manual online
2
HCD-ZX10D
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.
other than those specified herein may result in hazardous radiation
exposure.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK
0
OR DOTTED LINE
WITH MARK
0
ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
General
Power requirements
Australian model:
Australian model:
230 – 240 V AC,
50/60 Hz
50/60 Hz
Other models:
1
Mexican model:
127 V AC, 60 Hz
20 V, 220 V or
230 – 240 V AC, 50/60 Hz
Adjustable with voltage
selector
Adjustable with voltage
selector
Power consumption
370 watts
Dimensions (w/h/d) (Unit)
Approx. 362
× 437 ×
465 mm
Mass (Unit)
Approx. 20.0 kg
Design and specifications are subject to change
without notice.
without notice.
Tape deck section
Recording system
4-track 2-channel, stereo
Frequency response
50 – 13,000 Hz (
±3 dB),
using Sony TYPE I tapes
Tuner section
FM stereo, FM/AM superheterodyne tuner
FM tuner section
Tuning range
87.5 – 108.0 MHz
(50 kHz step)
(50 kHz step)
Antenna
FM lead antenna
Antenna terminals
75 ohms unbalanced
Intermediate frequency
10.7 MHz
AM tuner section
Tuning range
531 – 1, 602 kHz
(with the tuning interval
set at 9 kHz)
530 – 1, 710 kHz
(with the tuning interval
set at 10 kHz)
(with the tuning interval
set at 9 kHz)
530 – 1, 710 kHz
(with the tuning interval
set at 10 kHz)
Antenna
AM loop antenna
Antenna terminals
External antenna terminal
Intermediate frequency
450 kHz
This appliance is
classified as a CLASS 1
LASER product. This
label is located on the
rear exterior.
classified as a CLASS 1
LASER product. This
label is located on the
rear exterior.
The following caution label is located inside the
apparatus.
apparatus.
Ver. 1.1
Click on the first or last page to see other HCD-ZX10D / LBT-ZX10D service manuals if exist.