HCD-XB8, LBT-XB8AV, MDS-B5 - Sony Audio Service Manual (repair manual)

hcd-xb8, lbt-xb8av, mds-b5 service manual
Model
HCD-XB8 LBT-XB8AV MDS-B5
Pages
70
Size
1.46 MB
Type
PDF
Document
Service Manual
Brand
Device
Audio / S/M HCD-XB8 (GOES W/LBTXB8AV)
File
hcd-xb8-lbt-xb8av-mds-b5.pdf
Date

Read Sony HCD-XB8 / LBT-XB8AV / MDS-B5 Service Manual online

— 1 —
SERVICE MANUAL
COMPACT DISC DECK RECEIVER
MICROFILM
— Continued on next page —
HCD-XB8 is the tuner, deck, CD and
amplifier section in LBT-XB8AV.
Model Name Using Similar Mechanism
HCD-D670AV/N555AV
CD Mechanism Type
CDM37L-5BD29AL
Base Unit Type
BU-5BD29AL
Optical Pick-up Type
KSS-213D/Q-NP
Model Name Using Similar Mechanism
HCD-D670AV/N555AV
Tape Transport Mechanism Type
TCM-220WR2
CD
SECTION
TAPE
DECK
SECTION
SPECIFICATIONS
HCD-XB8
AEP Model
UK Model
E Model
Australian Model
PX Model
Photo : AEP model
— 2 —
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous ra-
diation exposure.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
 damaged by heat.
Flexible Circuit Board Repairing
• Keep the temperature of soldering iron around 270˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
 circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
 or unsoldering.
Laser component in this product is capable of emitting radiation
exceeding the limit for Class 1.
This appliance is classified as
a CLASS 1 LASER product.
The CLASS 1 LASER PROD-
UCT MARKING is located on
the rear exterior.
This caution
label is located
inside the unit.
MODEL IDENTIFICATION
— BACK PANEL —
• Abbreviation
AUS: Australian model
AR : Argentine model
SAF : South Africa model
MX : Mexican model
EE : East European model
AEP, UK model
EE, CIS model
E, AR, SAF model
AUS model
PX model
MX model
MODEL
PARTS No.
4-987-045-0 
4-987-045-2 
4-988-222-0 
4-988-222-1 
4-988-222-2 
4-988-222-3 
Parts No.
— 3 —
TABLE OF CONTENTS
1. GENERAL
.......................................................................... 4
2. DISASSEMBLY
2-1. Front Panel ........................................................................... 5
2-2. Main Board ........................................................................... 6
2-3. Tape Mechanism Deck .......................................................... 6
2-4. Cassette Lid Assembly .......................................................... 7
2-5. CD Lid assembly ................................................................... 7
2-6. CD Mechanism Deck ............................................................ 8
2-7. Base Unit ............................................................................. 8
2-8. Disc Table ............................................................................. 8
3. SERVICE MODE
........................................................
9
4. MECHANICAL ADJUSTMENTS
..........................
11
5. ELECTRICAL ADJUSTMENTS
............................... 11
6. DIAGRAMS
6-1. Circuit Boards Location ...................................................... 18
6-2. Brock Diagrams
• Tuner Section (AEP, UK model) ..................................... 19
• Tuner Section (East European, CIS model) ..................... 21
• CD Section ....................................................................... 23
• Deck Section .................................................................... 25
• Main Section .................................................................... 27
• Power Section .................................................................. 29
6-3. Printed Wiring Board —CD Section — .............................. 31
6-4. Schematic Diagram — CD Section — ............................... 33
6-5. Printed Wiring Board
—Tuner (AEP, UK model) Section — ................................ 36
6-6. Schematic Diagram
—Tuner (AEP, UK model) Section — ................................ 37
6-7. Schematic Diagram
—Tuner (East European, CIS model) Section — ............... 39
6-8. Printed Wiring Board
—Tuner (East European, CIS model) Section — ............... 41
6-9. Printed Wiring Board — Main Section — .......................... 42
6-10. Schematic Diagram — Main Section — .......................... 45
6-11. Schematic Diagram — Deck Section — .......................... 49
6-12. Printed Wiring Board — Deck Section — ....................... 53
6-13. Schematic Diagram — Panel Section — ......................... 56
6-14. Printed Wiring Board — Panel Section — ....................... 59
6-15. Schematic Diagram — Power Section — ........................ 63
6-16. Printed Wiring Board — Power Section — ..................... 67
6-17. Schematic Diagram — CD Motor Section — .................. 70
6-18. Printed Wiring Board — CD Motor Section — ............... 71
6-19. IC Block Diagrams ........................................................... 73
6-20. IC Pin Functions ............................................................... 80
7. EXPLODED VIEWS
7-1. Case and Back Panel Section .............................................. 89
7-2. Front Panel Section 1 .......................................................... 90
7-3. Front Panel Section 2 .......................................................... 91
7-4. Chassis Section ................................................................... 92
7-5. TC Mechanism Section 1 (TCM-220WR2) ........................ 93
7-6. TC Mechanism Section 2 (TCM-220WR2) ........................ 94
7-7. TC Mechanism Section 3 (TCM-220WR2) ........................ 95
7-8. CD Mechanism Section (CDM37L-5BD29AL) ................. 96
7-9. Base Unit Section (BU-5BD29AL) .................................... 97
8. ELECTRICAL PARTS LIST
........................................ 98
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK
OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
break-down because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repain parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, when checking the laser diode emission, ob-
serve from more than 30 cm away from the objective lens.
LASER DIODE AND FOCUS SEARCH OPERATION
CHECK
Carry out the “S curve check” in “CD section adjustment” and check
that the S curve waveform is output three times.
SAFETY-RELATED COMPONENT WARNING !!
COMPONENTS IDENTIFIED BY MARK 
!
 OR DOTTED LINE
WITH MARK 
!
 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS
WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS
MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
— 4 —
SECTION 1
GENERAL
Front Panel
1
7 8
9
!º !¡
!∞
@•
#™
2
3
4
6
@™
@∞
#∞
$•

%∞
!™
$™
$∞

%™
%•
^™
5
!•
#•
Page of 70
Display

Download Sony HCD-XB8 / LBT-XB8AV / MDS-B5 Service Manual (Repair Manual)

Here you can read online and download Sony HCD-XB8 / LBT-XB8AV / MDS-B5 Service Manual in PDF. HCD-XB8 / LBT-XB8AV / MDS-B5 service manual will guide through the process and help you recover, restore, fix, disassemble and repair Sony HCD-XB8 / LBT-XB8AV / MDS-B5 Audio. Information contained in service manuals typically includes schematics / circuit diagrams, wiring diagrams, block diagrams, printed wiring boards, exploded views, parts list, disassembly / assembly, pcb.