Read Sony HCD-SLK10D / HCD-SLK20D / WHG-SLK10D / WHG-SLK20D Service Manual online
HCD-SLK10D/SLK20D
14
2-8. HOLDER (JACK) BLOCK
– Rear bottom view –
Note 1: Please spread a sheet under a unit
not to injure front panel.
2 wire (flat type)
(7
core)
(CN705)
1 Lift up the lead pin.
7 holder (jack) block
6 screw
(BVTP2.6)
3 Lift up the
clamp
(L35).
4 connector
(SLK10D:
CN601/
SLK20D:
CN603)
5 connector
(SLK10D:
CN602/
SLK20D:
CN604)
:ire VettiQJ
lead pin
80 mm
TERMINAL board
TERMINAL board
tape
filter clamp (ferrite core)
lead pin
clamp (L35)
JACK board
tape
filter clamp
(ferrite core)
(ferrite core)
cover (CDM) 86S
cover (CDM) 86S
Note 2: When you install the wire (flat type), please
install them correctly.
There is a possibility that this machine damages
when not correctly installing it.
Insert is straight
to the interior.
to the interior.
connector
Insert is incline.
wire
(flat type)
(flat type)
wire
(flat type)
(flat type)
connector
OK
NG
Note 3: Do not insert the wire (flat type) in the same amount of
connector by mistake. Refer to
“2-21. HOW TO BEND
WIRE
(FLAT
TYPE)” (page 24) and “5-1. FLAME
PRINTED WIRING BOARDS” (page 31) for details.
Click on the first or last page to see other HCD-SLK10D / HCD-SLK20D / WHG-SLK10D / WHG-SLK20D service manuals if exist.