Read Sony HCD-S20 Service Manual online
HCD-S20
9
2-5. LOADER (TDL-5) & OPU ASSY (CDM1)
1 Solder the short-land.
Note 2:
When assembling the loader (TDL-5) &
OPU assy (CDM1), remove the solder of
short-land after connecting all flexible flat
cable and connector.
2 screws (3)
2 screws (3)
5 connector
(XP3)
(XP3)
4 flexible flat cable
(XP2)
(XP2)
7 loader (TDL-5) & OPU assy
(CDM1)
(CDM1)
3 Remove the loader (TDL-5) & OPU
assy in the direction of an arrow.
6 connector (XP4)
Note
Note
3:
Since the wire is very thin, it is easy to cut.
When disconnecting, do it while holding the
connector
part.
.
Note 1: Before disconnecting the flexible flat cable of the loader (TDL-5) & OPU assy (CDM1), solder the short-land.
– Bottom view –
Note 4:
The wire is soldered to the
terminal of the switch.
Be careful so that not cut
or bend the terminal.
2-6. FRONT PANEL BLOCK
4 six claws
5 front panel block
– Rear right view –
3 connector
(XP12)
(XP12)
1 connector
(XP6)
(XP6)
2 connector
(XP9)
(XP9)
Wire setting
Wire from USB board is upper.
Wire from VFD board is lower.
– Rear view –
Note 2: These connectors have the same number of pins.
When connecting, be careful not to mistake.
VFD board
chassis
front panel block
Note 1: When installing the front panel
block, be careful not to bite the
wire at the chassis.
Click on the first or last page to see other HCD-S20 service manuals if exist.