HCD-S20 - Sony Audio Service Manual (repair manual). Page 3

The laser diode in the optical pick-up block may suffer electro-
static break-down because of the potential difference generated by 
the charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic break-down and also 
use the procedure in the printed matter which is included in the 
repair parts.
The fl exible board is easily damaged and should be handled with 
care.

NOTES  ON  LASER  DIODE  EMISSION  CHECK
The laser beam on this model is concentrated so as to be focused 
on the disc refl ective surface by the objective lens in the optical 
pickup block. Therefore, when checking the laser diode emission, 
observe from more than 30 cm away from the objective lens.

UNLEADED  SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution:  Some printed circuit boards may not come printed with 

the lead free mark due to their particular size)

Unleaded solder has the following characteristics.
•  Unleaded solder melts at a temperature about 40 °C higher 

than ordinary solder.

 

Ordinary soldering irons can be used but the iron tip has to be 
applied to the solder joint for a slightly longer time.

 

Soldering irons using a temperature regulator should be set to 
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if 

the heated tip is applied for too long, so be careful!

• Strong 

viscosity

 

Unleaded solder is more viscous (sticky, less prone to fl ow) 
than ordinary solder so use caution not to let solder bridges 
occur such as on IC pins, etc.

• 

Usable with ordinary solder

 

It is best to use only unleaded solder but unleaded solder may 
also be added to ordinary solder.

ABOUT  PART  REPAIR  OF  EACH  BOARD
The part that mounted on each board cannot exchange. When the 
mounted part is damaged, exchange with the complete mounted 
board or part including complete mounted board.
Printed wiring board and schematic diagram that have been de-
scribed on this service manual are for reference.

TEST  DISCS
Use following TEST DISC (for CD) when this unit confi rms the 
operation and checks it.

Part No.

   

Description

3-702-101-01 DISC 

(YEDS-18), 

TEST

4-225-203-01 DISC 

(PATD-012), 

TEST

RELEASING  THE  DISC  TRAY  LOCK
The disc tray lock function for the antitheft of sample disc in the 
shop is equipped.

Releasing Procedure:
1.  Press the [

?/1

] button to turn the power on.

2.  Press two buttons of the [x] on the remote commander and 

[Z] on the main unit simultaneously for fi ve seconds.

3.  The message “UNLOCKED” is displayed on the fluorescent 

indicator tube and the disc tray is unlocked.

Note: When “LOCKED” is displayed, the disc tray lock is not released by 

turning power on/off with the [?/1] button.

CAPACITOR  ELECTRICAL  DISCHARGE  PROCESSING
When checking the board, the electrical discharge is necessary for 
the electric shock prevention.
Connect the resistor to both ends of respective capacitors.

• POWER 

Board

 

CE501, CE502, CE534

:/2 W

:/2 W

:/2 W