HCD-RV660D, HCD-RV990D - Sony Audio Service Manual (repair manual). Page 16

Read Sony HCD-RV660D / HCD-RV990D Service Manual online

16
HCD-RV660D/RV990D
0 dB=0.775 V
DECK  SECTION
1. Demagnetize the record/playback head with a head
demagnetizer.
2. Do not use a magnetized screwdriver for the adjustments.
3. After the adjustments, apply suitable locking compound to the
parts adjust.
4. The adjustments should be performed with the rated power
supply voltage unless otherwise noted.
5. The adjustments should be performed in the order given in this
service manual.  (As a general rule, playback circuit adjustment
should be completed before performing recording circuit
adjustment.)
6. The adjustments should be performed for both L-CH and R-
CH.
7. Switches and controls should be set as follows unless otherwise
specified.
• Test Tape
Record/Playback Head Azimuth Adjustment
Note:
 Perform this adjustments for both decks

Procedure:
1. Mode:  Playback
Tape
Signal
Used for
P-4-A063
6.3 kHz, –10 dB
Azimuth Adjustment
DECK A      DECK B
set
MAIN board
IC601
Pin 
wh
 (L-CH)
Pin 
5
 (R-CH)
MAIN board
IC601
Pin 
qk
 (GND)
+
–
level meter
test tape
P-4-A063
(6.3 kHz, –10 dB)
2. Turn the adjustment screw and check output peaks. If the peaks
do not match for L-CH and R-CH, turn the adjustment screw
so that outputs match within 1dB of peak.
3. Mode:  Playback
4. After the adjustments, apply suitable locking compound to the
pats adjusted.

Adjustment Location: Playback Head (Deck A).
Record/Playback/Erase Head (Deck B).
screw
position
L-CH
peak
within
1dB
output
level
L-CH
peak
R-CH
peak
within
1dB
screw
position
R-CH
peak
MAIN
board
IC601
test tape
P-4-A063
(6.3 kHz, –10 dB)
pin 
5
oscilloscope
L-CH
R-CH
V
H
waveform of oscilloscope
in phase 45
°
90
°
135
°
180
°
good
wrong
pin 
qk
pin 
wh
L
R
forward
reverse

Display

Click on the first or last page to see other HCD-RV660D / HCD-RV990D service manuals if exist.

Random: