HCD-RG60, MHC-RG60 - Sony Audio Service Manual (repair manual). Page 17

17

Procedure:
1.

Supply a 98 MHz signal at 28 dB from the ANTENNA terminal.

2.

Tune the set to 98 MHz.

3.

Adjust RV101 to the point (moment) when the TUNED
indicator will change from going off to going on.

Adjustment Location: MAIN board

Procedure:
1.

Supply a 98 MHz signal at 60 dB from the ANTENNA terminal.

2.

Tune the set to 98 MHz.

3.

Measure voltage between pin 21 and pin 23 of IC 101.  Adjust
T101 ubtil the voltage becomes 0 V.

Adjustment Location: MAIN board

FM RF Signalgenerator

75 

Ω

 coaxial

Carrier frequency : 98 MHz
Modulation           : AUDIO 1 kHz, 75 kHz
                              deviation (100%)
Output level          : 28 dB  (at 75 

Ω

 open)

FM ANTENNA terminal
(TM101)

set

FM RF Signalgenerator

75 

Ω

 coaxial

Carrier frequency : 98 MHz
Modulation           : AUDIO 1 kHz, 75 kHz
                              deviation (100%)
Output level          : 60 dB  (at 75 

Ω

 open)

FM ANTENNA terminal
(TM101)

set

Note :

1. CD Block is basically designed to operate without adjustment.

Therefore, check each item in order given.

2. Use YEDS-18 disc (3-702-101-01) unless otherwise indicated.
3. Use an oscilloscope with more than 10M

Ω impedance.

4. Clean the object lens by an applicator with neutral detergent

when the signal level is low than specified value with the
following checks.

Procedure :
1. Connect oscilloscope to TP (FEO).
2. Connect between TP (FEI) and TP (VC) by lead wire.
3. Connect between TP (AGCCON) and TP (D GND) by lead wire.
4. Turn Power switch on.
5. Load a disc (YEDS-18) and actuate the focus search. (In

consequence of open and close the disc tray, actuate the focus
search)

6. Confirm that the oscilloscope waveform (S-curve) is

symmetrical between A and B. And confirm peak to peak level
within 4 

±1 Vp-p.

7. After check, remove the lead wire connected in step 2 and 3.

Note : • Try to measure several times to make sure than the ratio

of A : B or B : A is more than 10 : 7.

• Take sweep time as long as possible and light up the

brightness to obtain best waveform.

Procedure :
1. Connect oscilloscope to TP (RF).
2. Connect between TP (AGCCON) and TP (D GND) by lead wire.
3. Turned Power switch on.
4. Load a disc (YEDS-18) and playback.
5. Confirm that oscilloscope waveform is clear and check RF signal

level is correct or not.

6. After check, remove the lead wire connected in step 2.

±1Vp-p

T101

RV661

RV101

IFT101

T102

RV661:TAPE SPEED

T101:NULL

RV101:FM TUNED LEVEL