Read Sony HCD-RG30 / MHC-DX20 / MHC-RG30 Service Manual online
4
HCD-DX20/RG30
SECTION 1
SERVICE NOTE
1
Connector
13p (CN712)
2
Cut the seven melted-connection points
with a cutting plier.
4
Cut the six melted-connection points
with a cutting plier.
3
Panel board
5
Key board
Panel board
(ten screw holes)
(ten screw holes)
Key board
(eight screw holes)
(eight screw holes)
Screw hole
In order to re-install the panel board and the key board,
fix them by using the screws (+BVTP 2.6
fix them by using the screws (+BVTP 2.6
×
8 ) respectively.
Screw in to the respective screw holes.
Do not tighten the screws excessively.
Do not tighten the screws excessively.
* The panel board and the key board only are connected to the front panel
by means of hot-melting the plastics.
by means of hot-melting the plastics.
Note for installing the panel board and the key board
REMOVING THE PANEL BOARD AND THE KEY BOARD
Apply HANARL SLF-9 (7-400-000-00) to the
position of the figure.
position of the figure.
: Apply HANARL
NOTE FOR CHASSIS EXCHANGE
Hot melt
Chassis
Ver1.2 2003.01
Click on the first or last page to see other HCD-RG30 / MHC-DX20 / MHC-RG30 service manuals if exist.