HCD-N555AVK, LBT-N555AVK - Sony Audio Service Manual (repair manual). Page 2

— 2 —

Recording system

4-track 2-channel stereo

Frequency response

40-13,000 Hz (±3 dB), using
SONY TYPE I cassette
40-14,000 Hz (±3 dB), using
SONY TYPE II cassette

Wow and flutter

± 0.15% W.Peak (IEC)
0.1% W.RMS (NAB)
± 0.2% W.Peak (DIN)

Peak music power output:

1,400 W (6   a t 1 kHz, 10% THD)

Continuous RMS power output:

FRONT SPEAKER
45 W + 45 W (6 ohms, at 1 kHz, 5% THD)
SUPER WOOFER
45 W + 45 W (6 ohms, 5% THD)
SURROUND CENTER SPEAKER
40 W (8 ohms, at 1kHz 5% THD)
SURROUND REAR SPEAKER
20 W + 20 W (16 ohms, at 1 kHz, 5% THD)

Inputs
PHONO (phono jack):

Sensitivity 3 mV, impedance 47 kilohms

LD/VIDEO (AUDIO) (phono jack):

Sensitivity 250 mV, impedance 47 kilohms

MIC (phone jack):

Sensitivity 1 mV, impedance 10 kilohms

Outputs
PHONES (phone jack):

accept headphones of 6 to 16 ohms

FRONT SPEAKER: accept impedance of 6 to 16 ohms
SURROUND SPEAKER CENTER:

accept impedance of 8 to 16 ohms

SURROUND SPEAKER REAR:

accept impedance of 16 ohms

SUPER WOOFER:

accept impedance of 6 to 16 ohms

Power requirements

Malaysia model:

220-240 V AC, 50/60 Hz

Other models:

110-120 V or 220-240 V AC
adjustable, 50/60 Hz

Power consumption

240 W

Dimensions

Approx. 355 x 425 x 400 mm (w/h/d)
incl. projecting parts and controls

Mass

Approx. 13 kg

Design and specifications subject to change without notice.

Laser component in this product is capable of emitting radiation
exceeding the limit for Class 1.

This appliance is classified as a
CLASS 1 LASER product.
The CLASS 1 LASER PRODUCT
MARKING is located on the rear
exterior.

• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be

damaged by heat.

• Keep the temperature of soldering iron around 270˚C

during repairing.

• Do not touch the soldering iron on the same conductor of the

circuit board (within 3 times).

• Be careful not to apply force on the conductor when soldering

or unsoldering.

CAUTION

Use of controls or adjustments or performance of
procedures other than those specified herein may result in
hazardous radiation exposure.

This caution label
is located inside
the unit.

!

!